Crankcases and PCV Valves
Chevy Corsica
Grand Am SE

Where is PCV valve located on 1992 Chevy Corsica?

383940

Top Answer
User Avatar
Wiki User
2005-02-04 23:57:33
2005-02-04 23:57:33

typically in the valve cover.

1
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions

User Avatar

SIGN UP FOR ALLDATA.COM TO BE SURE. IT IS SO WORTH YOUR TIME AND TROUBLE. T HEMPLE there is no egr valve in a 1992, the manual says so

User Avatar

The radiator drain on a 1992 Chevy Corsica is located on the bottom, left side of the radiator. It provides a quick and effective way to drain the radiator during maintenance.

User Avatar

It is located on the drivers side of the car on the bottom of the radiator

User Avatar

The 1992 Chevrolet Corsica ignition module can be found on the firewall in the engine compartment. The ignition module will be on the drivers side of the firewall.

User Avatar

It will take an experience mechanic approximately 8 hours to replace the timing belt in your 1992 Chevy Corsica. The 1992 Chevy Corsica does not have each timing chain, it has a timing belt.

User Avatar

The PCV valve is located on the backside valve cover, its towards the drivers side of the valve cover, tough to get at not much room, just changed mine.

User Avatar

The PCV valve on a 1992 Chevy 1500 350 is located on the intake manifold which is on the passenger side of the vehicle and to the right of the throttle. It has two bolts that hold it in place.

User Avatar

the pcv is located under the fuel injection plenum, towards the back of the engine as opposed to some newer models that have this valve located in the front of the engine on the valve cover

User Avatar

Check all the passageway it may be blocked with carbon and other exhaust dirt. the (EVP) may also be faulty (exhaust valve position sensor)

User Avatar

You'll find the location for the 4 & 6 cylinder in this pic. http://autorepair.about.com/library/faqs/bl826b.htm

User Avatar

Put the new serpentine belt on to your 1992 Chevy Corsica pulleys. Push the tensioner pulley to the left to tighten the serpentine belt.

User Avatar

on steering wheel colum,the turn switch works it

User Avatar

located in the fuel tank of a 1992 corsica ,it may be the same for your model if this is so you may need to drop the tank . I would notadvice you to take on this job unless you have to.

User Avatar

Since the 92 Chevy Corsica is equipped with SRS (Saftey Restraint System), ie: Airbags, which is located in the steering wheel. In order to replace the turn signal switch you must remove the steering wheel. Therefore I would only highly advise you to take it to a dealer to have this done.

User Avatar

There are several located in back of radiator close to the starter.

User Avatar

it is located on the passenger side valve cover

User Avatar

Passenger side top of engine, in front of the alternator.

User Avatar

It uses DEXTRON III automatic trans fluid.

User Avatar

Drivers side of the engine, behind the throttle body. Called a DEGR. Check into the alldata.com vehicle site to get all the info on your vehicle, it cost $14.95 a year but so well worth it, has everything you can imagine for your vehicle. T HEMPLE

User Avatar

That year model did not have a modulator valve on the transmission.

User Avatar

In the middle of the valve cover nearest the firewall.


Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.