answersLogoWhite

0


Best Answer

It is located between the camshafts right behind the camshaft pulley's.

User Avatar

Wiki User

โˆ™ 2006-05-21 21:35:36
This answer is:
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
User Avatar

Add your answer:

Earn +20 pts
Q: Where is a camshaft position sensor on a 2001 Isuzu rodeo?
Write your answer...
Submit
Related questions

What does code PO341 mean on a Isuzu Rodeo?

PO341 Camshaft Position Sensor Circuit Range Problem


How do you repair camshaft sensor on Isuzu Rodeo?

please help


Where is a camshaft position sensor on a 2002 Isuzu rodeo 3.2L?

it does not have one, after 2000 modes the camshaft position sensor is eliminated the these vehicles use the use the VRS system to determine where the No. 1 piston is. therefore they only required a Crankshaft sensor not a Camshaft sensor.


Where is the camshaft position sensor on 1998 Isuzu rodeo?

On the drivers side head..rear of the head directly behind the intake manifold


How long does it take to replace the camshaft position sensor in a Isuzu Rodeo?

Not long at all should take no longer then 5 mins


What is the tps sensor on a 95 Isuzu Rodeo?

It is a Throttle Position Sensor


Where is the camshaft position sensor on 1996 Isuzu rodeo?

On 97 & earlier it's located on the front left upper corner of the timing belt cover (3.2L). 2.2L it's on top of the front part of the cylinder head between the camshaft sprockets.


How do you replace coolant temp sensor on a Isuzu Rodeo?

how do you replace coolant temp sensor on a rodeo


What does O2 sensor mean on Isuzu Rodeo?

oxygen sensor


Where exactly is the location of the camshaft position sensor on your 2002 Isuzu rodeo 2.2L?

look at the top of the engine, the cover for the spark plugs ends at the front of the engine. Right at that point is where the connector is, to get at the sensor you must remove the serpentine belt, wiring cover, and timing belt cover, and the sensor bolt can be accessed between the camshaft pulleys, its a small torx bolt.


Where is the camshaft position sensor on a 2003 Isuzu rodeo 3.2?

If this is a 6VD1 engine, the camshaft position sensor will be located on the very back of the left bank head (on the inside, under the intake manifold). The easiest way to have it replaced or removed is to take off the intake manifold. The sensor is only secured with one 10mm bolt but it is a frustrating thing to put it back on with the intake installed, unless you have very slim hands.


What does diagnostic code P0342 mean on Isuzu Rodeo?

Indicates a fault with the camshaft position sensor circuit. Either the sensor itself, or the wiring for it is faulty. If it occurs after replacing heads or engine assembly, check to make sure it is plugged in completely and that no damage was done to wiring harness.


How do you replace coolant temperature sensor 2002 Isuzu Rodeo?

En donde esta localisado el sensor de coolant en la isuzu rodeo 2002 4 cilindro


How many oxygen sensors does an Isuzu Rodeo have?

The Isuzu Rodeo can have 3 or more oxygen sensors. The oxygen sensor delivers information to the powertrain module.


Location of oxygen sensor for Isuzu rodeo 1993?

On exhaust manifold.


Crankshaft sensor 1997 Isuzu Rodeo?

on the right side of the engine


Check engine 2001 Isuzu Rodeo?

The check engine light for the 2001 Isuzu Rodeo often comes on because of a sensor that is damaged or malfunctioning. The most common sensor is an oxygen sensor and when reset, this often allows the light to be reset.


Where is the gravity rollover sensor located on a Isuzu Rodeo?

It may be located in the airbag sensor control unit.


Where is the temperature sensor in a 94 Isuzu Rodeo 3.2L V6?

under the hood


Where is the throttle position sensor on a 2001 Isuzu rodeo?

THERE IS ONE ON THE GAS PEDAL AND ONE IN THE THROTTLE BODY. THIS VEHICLE DOES NOT USE A THROTTLE CABLE, IT HAS WHAT IS CALLED " FLY BY WIRE " .


Where are the oxygen sensors on 1997 Isuzu Rodeo?

it depends on the model of engine, my 97 rodeo with the 4ze1 motor has the map sensor for air intake but doesnt have an O2 sensor for the exhaust.


When did they stop making the Isuzu Rodeo?

The last Isuzu Rodeo was in 2004.


Where is the crankshaft position sensor for 95 Isuzu rodeo 3.2l?

Passenger side of the block. You can see it through the passenger side wheel well. You will need long long extention.


Location of speed sensor 1993 Isuzu rodeo?

For the ABS it is on the left side of the rear axle.


What is the problem with your Isuzu rodeo if it stays idled up?

EGR or Mass air flow sensor