Home
Where is and how do you access the brake light fuse on a 1992 Chevy G20 v6?
Your Answer
Still Have Questions?
Related Questions
How do you install a brake light switch for a 1992 Chevy lumina?
It is quite easy to install the 1992 Chevy Lumina brake light switch. The brake light switch simply plugs in and out.
Why is my brake light on in a 1992 Chevy Blazer?
you most likely need to change them
How do you change the brake light in a 1992 Lincoln Continental?
remove the trunk lining or bend it back easy where the brake light is to access it and change it out.
Chevy 1992 s10 pu no brake lights?
Check the bulbs, Check the fuse, Check the brake light switch, in that order.
1992 Chevy silverado and your emergency brake don't work and your brake light is on?
Pull the release handle for the e brake and then while its pulled out pull up on the pedal
How do you get the brake warning light to go off on a 1992 Chevy Corvette?
By repairing the problem. Low brake fluid, defective master cylinder, etc.
My third brake light on 1992 Chevy beretta not working any suggestions?
if its burnt out, replace it, if not, check the wireing
1992 Chevy caprice brake light stays on but the brakes are off?
brake light plunger switch on the brake pedal maybe faulty, remove it and connect the two wires together and pull apart and see if lights go on and off
How to fix brake lights that stay on on a 1992 Chevy silverado truck?
Bad stop light switch? Located at the upper end of the brake pedal under dash area
Where is the sig lite flasher on 92' Chevy Silverado?
The signal light flasher on a 1992 Chevy Silverado is under the dash. It is on the driver's side just above the brake pedal.
Why are the brake light and antilock brake light coming on and staying on in my 1992 Pathfinder?
your brake fluid is probably low or very dirty.
Where is the Brake Light Switch on a 1992 Dodge 250 Diesel?
the brake light switch is on a bracket just above the brake pedal.
What is wrong if the brake light is constantly on in a 1992 crown Victoria?
Normally this is an indication of a defective brake light switch.
What is a code 38 on a 1992 Chevy Van?
If you are getting a code 38 on a 1992 Chevy van, it means that the brake switch is stuck in stop mode. This will also cause your cruise control to not disengage when you press your brake pedal.
How do you change the brake light switch on a 1992 Chevy Lumina with Cruise control?
the brake light switch is located on the brake padal bracket just to the right of the steering column mount. you'll need to remove the left underdash sound panel beneath the steering column to get to the switch and connector.
Where is the hydraulic clutch reservoir on a 1992 Chevy pick up?
It is by the brake master cylinder
How do you repair a 1992 Dodge Caravan when the brakes lock up and the brake light stays on?
The dealer will know how to access the codes for the brakes. When that is fixed it should not lock up then.
What is wrong with your cruise control on your 1992 Chevy Caprice?
I have a 93 Caprice and the cruise went out a few times. Check the third brake light in the back of the window. If it is out replace it and this might fix the problem. Also check the fuse as it controls the cruise and third brake light as well.
1992 Lincoln town car No brake lights and will not go into gear after you star it?
Check for a blown brake light fuse ( in the fuse panel ) or the brake light switch at the brake pedal could be the problem. The brake light switch releases the shifter lock as well as operating the brake lights.
Where would the brake light switch be on a 1992 Ford F150?
Under the dash near the brake pedal lever.
Why would the parking brake light be on even though the parking brake is not on for a 1992 Buick Centry?
I have a 1992 Chevrolet lumina and I had the same problem. what that means is your brake fluid is at a low level so check that.
Why does the brake warning light come on in a 1992 caprice?
Either the brake fluid level is LOW in the brake master cylinder located in your engine compartment , or the parking brake / emergency brake is on
Your brake light sw is working and your brake lights still remain on for your 1992 Mazda Protege?
Switch is defective or out of adjustment.
Where is the brake light switch located on a 1992 Kenworth w900?
It will be mounted to a pressure port on the service (foot) brake valve
Where is the brake light fuse located in a 1992 Jeep Wrangler?
the brake light fuse is located on the firewall under the dash beside the park brake second or third up on the left hand side
Still have questions?
