I DONT KNOW FOR CERTAIN. WHEW!!! THAT WAS SO HARD TO SAY!!! IT MAY BE ACCESSIBLE UNDER THE OIL PAN, IF THE OIL PUMP IS NOT IN THE WAY. AGAIN, THESE ARE GUESSES.GO TO AUTOZONE AND PEEK IN ONE OF THEIR REPAIR MANUALS...GOOD LUCK!..BB
Try checking for the crankshaft sensor
Dodge did not produce the Durango until 1998. It is located on the bell housing on the right side of the engine where the transmission mounts to the engine
how do i change to front brakes on a dodge durango?
A 1999 Durango does not have any part called a GPS sensor.
where is the crankshaft sensor on a 1994 dodge pickup with a 5.9l engine?
The 2006 Dodge Durango camshaft position sensor is located on the back end of the head. The position sensor should be labeled as such.
How do you change shift cylinoid on 1998 dodge Durango
where is the crankshaft sensor located on a 1993 dodge intrepid
The backup sensor is inside the transmission.
uh what transmission. what sensor
opn pasenger side , near beel housing ,halfway down block. Remove tire and you will see it
Change the sensor located on rear-end housing
The oxygen sensor is located in the exhaust system on a 2005 Dodge Durango Hemi 5.7. There is a sensor located before and after the catalytic converter.
The crankshaft sensor is located on top of the transmission at the passenger side.
The crankshaft position sensor on a 2005 dodge caravan is mounted on the top side of the bell-housing.
Under the timing chain, on the front of the crankshaft.
You will have to remove the parts that are in the way. Most likely it is the starter.
The crankshaft position sensor on a 2005 dodge grand caravan is located on the top side of the bell housing.
The Crankshaft Position (CKP) sensor is located at the right-rear side of the engine cylinder block CKP Sensor Location/Removal/Installation - 4.7L V - 8 Engine It is positioned and bolted into a machined hole in the engine block
The crankshaft sensor is located directly above the oil filter housing by the alternator.
it is a 1 1/4 ( hollywood)
Under the timing chain on the nose of the crankshaft.
TPC= throttle position sensor.
No, the cam sensor is a flat plate under the distributor cap. The crank sensor is a round sensor with a mounting tab behind the passenger side cylinder head.
Take off the old one and put the new one on.