answersLogoWhite
Ask
Heater Cores and Blower Fans
Oldsmobile Intrigue
Ford Ranger XLT

Where is blower motor resistor on a 1999 Olds Intrigue located?

656667
Answer

Top Answer
User Avatar
Wiki User
2009-12-31 05:10:22
2009-12-31 05:10:22
Disconnect the battery negative cable. !!!Power is still on when ignition switch off!!!

I have Olds Intrigue 2000. Blower control resistor (Controller) located behind the

blower motor. Very close to the firewall.

Using 5.5 mm. socket remove the blower first. (3 screws are holding the blower)

Using the same socket (5.5 mm) remove one visible screw which holds the resistor.

You will have to loosen two other screws, located between the resistor and firewall. You don't need to remove them completely, just loosen them! And it is a pain in the neck to get there!!!

Resistor slides out when rear screws are loose.

--------------------------------------------------------------------------------------------------------

Answer

The resistor is under the glove box behind the blower motor. The motor is actually connected to the resisitor and the other connection on the resisitor comes from the climate control and relays. The part is right against the fire wall making it hard to get to. You need a socket and much patience to remove it. Good Luck.

1
0

Copyright © 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.