answersLogoWhite
Brake Pads and Rotors
Ford Focus
Ford Expedition XLT

Where is brake bleeding valve on a Ford Focus?

353637

Top Answer
User Avatar
Wiki User
2006-07-12 02:36:14
2006-07-12 02:36:14

There are four. One at each wheel. Look behind each wheel and you will see the calipers on the front wheels, and you will see either calipers or a backing plate on the rear. On each caliper there will be a bleeder screw at the top, and if you have backing plates on the rear wheels, there will be a bleeder screw sticking out just above the center.

1

Related Questions

User Avatar

The brake valve is located next to the master brake cylinder. The valve can be found just below the master brake cylinder.

User Avatar

solenoid 2 valve ford focus

User Avatar

how change brake fluid . i have ford focus lx 2000.ans how change air filter.

User Avatar

How do you remove the brake light cover on a ford focus

User Avatar

On a 2001 Ford Focus : The brake fluid reservoir is used for the brake and clutch systems

User Avatar

where is the pvc valve on a 2002 ford focus dual overhead cam ztec 2.0

User Avatar

where is the suction recharge value on a 200 ford focus

User Avatar

Use a helper to pump the Ford Focus brake pedal several times. While holding the pedal down, open a wheel bleeder valve and let air and fluid out. When the pedal reaches the floor, close the valve and pump the pedal again. After several times, the air will be out of that area, move to another wheel and repeat the process.

User Avatar

change rear pads ford focus estate 2005

User Avatar

its in the valve cover by the brake booster

User Avatar

the tailgate opens when i have braked in a ford focus automatic the tailgate opens when i have braked in a ford focus automatic

User Avatar

See answer on "How do you change the front brake pads on a 2001 Ford Focus?" for a description of the location of the resivoir. The answer to this exact location is at the bottom of that answer.

User Avatar

The EGR Valve is located in the engine compartment on the Ford Focus. The EGR Valve is set almost dead center into the top of the motor. The EGR Valve looks like a small carburetor with caps on the top and sides.

User Avatar

The bleeder valve for the brakes on a 1997 Ford Ranger is located in the brake line where it meets the brake disc. The wheel will have to be removed to access the bleeder screw for drum brakes.

User Avatar

The ford focus has a fixed orrifix in the pipe from the evaporator to the condenser .it is replaceable with a special tool. It does not have a mechanical expansion has such.

User Avatar

Is it a woman who asked this question?

User Avatar

The AC recharge valve for a 2003 Ford Focus with a Zetec engine is near the firewall. It is the larger of the two lines going to the compressor.

User Avatar

On the ford foucs 2000 need to adjustment yes or no

User Avatar

at the top of each wheel cylinder

User Avatar

In North America ( DOT 3 brake fluid ) meeting Ford specification ( ESA-M6C25-A )


Copyright © 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.