There is an intake and exhaust cam sensor, both are located at the front of the engine in the head. They have 2 wire/pin connectors. They intake cam sensor is the one on the driver's side. See orange circle in picture/link below.
no
It is a sensor that reads the rotational position of the camshaft. The engine computer uses that to control ignition and fuel timing.
This. is the sensor found on the cylinder head in the vicinity of the camshaft which inform the ECM of its position, so the. spark.could be sent to the cylinder for ignition.of the cylinder.
The crankshaft sensor on a 2 door Honda Accord with a 3L V6 engine is located on the side of the engine, near the oil filter. It screws into the side of the block and outputs the loading of the crankshaft to the vehicle's computer.
Inside the timing chain cover there is a crank position sprocket and a sensor that connects into the side of the timing chain cover. There is also a sensor in the distributor(this is the camshaft position sensor). The connector faces the firewall. To setup your timing you have to rotate the distributor to 0 deg or you will get a P1345 code. A timing light won't help. If you don't have the right equipment you need to take it to the dealer or keep adjusting the distributor until the code goes away. Jon
where is the g sensor in Ml320 2001
Where is the camshaft position sensor on a 2005 Expedition?
The 1995 for Crown Victoria camshaft position sensor can be found on the back of the cylinder head. The camshaft position sensor will be labeled as such.
location of the camshaft sensor
Do you have a video of the hhr camshaft position sensor
There isn't a camshaft position sensor. If you are asking because of an error code you received, it is caused by a signal that mimics the same signal as a camshaft position sensor.
The Pontiac 2.2 liter engine camshaft position sensor can be found on the back of each cylinder head. The camshaft position sensor should be labeled as such.
The Camshaft sensor is located in the distributor.
The camshaft position sensor is located on the end of the camshaft housing, on a 2002 Daewoo. The sensor should be labeled as such.
no
by the camshaft
The camshaft Hall-effect sensor is located at the front of the engine (standing at front of the car) to the right close to thermostat valve. It is suplied with voltage from de relay module.