driver side on the back of the motor where is crak sensor on 94 jeep 4.0 grand Cherokee
It cost me $243, that included a charge for diagnostic.
Crank sensor is on the driver side of the bell housing, Cam sensor is in the distributor. Computer is mounted to the inner fender.
The crank sensor is on the top driver side of the bell housing.
It has both, The crank sensor is on the timing cover passenger side behind the balancer. The cam sensor is the distributor, Inside of it.
what size engine 2.2
Behind the crank pulley
Do you have a 4.3L with a distributor? If so, the crank sensor is in the distributor and may also be called an HEI pickup or Hall switch.
no spark, no start
The crankshaft position sensor is located on the front side of the engine block near the flywheel/driveplate
If its a 3.0 td model the crank sensor is situated on the o/s in the engine casing , its accesible from underneath with a long extension and a 10mm socket
The crank sensor probably needs to be replaced.
Idk about the 99 civic but on my 95 jdm d15 the crank shaft position sensor is in the distributor. If the sensor is bad then you must replace the whole distributor. A bad wire could also cause this problem. Hope that helps good luck. jdmd15crx
It is part of the latch inside the door.
Did you replace the crank shaft sensor? was that the problem? my jeep is doing the same but i only have 85k on a 99'
No, it just makes it a easier job.
4.3L? Behind the bottom pulley, on the passenger side.
It is mounted on the side of the timing cover on the front of the engine behind the harmonic balancer.
The crankshaft sensor for the 5.2L Chrysler models is on the transmission bell-housing. It is above the starter, I had to remove the starter in order to get to the sensor. After that it was a piece of cake.
IT SHOULD BE LOCATED UNDER THE MANIFOLD BOLTED TO THE BLOCK
AnswerIts most likely to be the Crank Position Sensor (CPS) failing.
All Northstars have 2 crank sensors, there are located just to the side of the oil filter adapter & behind the front motor mount. I strongly you forget about figuring out which one is sensor A & which is sensor B. Replace both! 93-99 are the same part number for both sensors & are interchangeable. 2000+ have 2 different part numbers for each sensor & are not interchangeable with the 93-99 sensor.
The water pump is located on the front of the engine right above the crank pulley.