junk yard or auto parts store
it is under the intake manifold. very hard to see and no fun to remove.
You need the right tools to start with. Look by the manifold intake and remove a piece that looks like a valve next to the manifold intake. then put the new one on and hope it fits nicely. After you install the PCV Valve jump up and down with joy and kick your butt.
where is camshalf pulley ignition timing location for 1992 Toyota corolla?
yes they are the same cars from 1992 to 1997
Which type of transmission is in a 1992 Toyota corolla? In: http://wiki.answers.com/Q/FAQ/984 [Edit categories]
Where is the OBD port 1992 Toyota Corolla? Read more: http://wiki.answers.com/Q/Where_is_the_OBD_port_1992_Toyota_Corolla#ixzz2U40NKr4K
The oil filter is typically located under the hood in most vehicles. This is also true for the 1992 Toyota Corolla.
How do you change oxygen sensor in 1992 Toyota corolla? Is there a model engine 4A-FE without a oxygen sensor?
Yes, there is a diagram of a 1992 Toyota Corolla Engine. This diagram can be found in the cars specific maintenance manual, found in auto part stores.
If you have the 7MGE engine: Then the knock sensor is screwed into the engine block, directly underneath the intake manifold.
A 1992 Toyota Corolla can take any type of standard antifreeze. It should be labeled as being suitable for all makes and models of cars.
The true value of a 1992 Toyota Corolla is what a person is willing to pay for it. The approximately resale value varies greatly but is usually between $500 and $1500.
The intake air temperature sensor on a 1992 Toyota 4Runner will be found on the intake system. The unit is clipped into the plastic piping of the intake.
on the intake manifold.
anyone has pictures out there for how to replace door handles for 92 Toyota corolla?
The 1992 Toyota Corolla dashboard light fuse can be found in the fuse box. The dashboard light fuse will be listed as the instrument panel fuse.
what are the torque specs and sequence for a 1992 Nissan maxima manifold
There is no difference,,,
get a rebuilt you will be better off
The VE Corolla does not. All others do.
Yes, they both have the same engine, a 4A**
Just below the intake manifold.
on the back side if engine under intake manifold on the back side of engine under intake manifold
The spark plug gap for a 92 Corolla is .032, according to Autozone.
You don't. It has a timing chain
The e36 M50 has a timing chain. The e30 has a belt. Black plastic intake manifold = Chain Metal intake manifold = Belt
On the 1992 2.3 it is behind the upper intake manifold, about even with the lower intake manifold (driver's side).This puts it between the manifold and the firewall.
I'm almost certain it's under the intake manifold
type your answer here...
add intake chip from eBay and put an exhaust.
i have been told it is 60lb
One reason why fuel and temperature gauges would stop working on a 1992 Toyota Corolla would be a short in the wires. This would lead to a blown fuse. Check the fuse and replace it.
It is on the intake manifold closes to the TBI, it will be the black one.
got 175/70/13 on mine...
heat and a heavy hammer the larger the better
1992 models (sedans and wagons) had 102 horsepower. The 130 horsepower engine in the Corolla GT-S was only available through 1991, since that coupe model was dropped for 1992.
UNFORTUNATELY IT IS UNDER THE UPPER INTAKE MANIFOLD
An educated guess: 5 1/2 inch round - this is the case in my 1992 Corolla.
you need manifold vacuum for the brake booster.. (intake manifold)
just below the throttle body on the intake manifold an easy way to find it is to follow the little coper tube that goes from the front exhaust manifold to the intake.
The PCV valve is located in the back of the lower intake manifold. It should have a 3/8" hose going from the PCV valve to a vacuum source on the upper intake manifold.
The same place you check it at.
It is on the firewall below the master cylinder, drivers side
I have seen them with over 300,000Km and still going strong
the manual says it holds 13 gallons.
Of Course not. That's a foolish question.
It should be similar to a 1991. (Major changes came in 1993.) Standing in front of the car, looking under the hood, look just behind the battery, where the intake air temp sensor is mounted on a filter housing. Hope this helps.
The starter for a 1992 Lexus Ls400 is located under the upper intake manifold beneath the car. To access the starter you will need to first remove the manifold.