There are 2 of them on that engine and both of them are UNDERNEITH the intake manifold. You can't see them are service them until you remove the intake manifold.
Need to know the engine size. YOU will need to ASK your question again. THANK YOU.
on a 99 model there are two of them and its located under the intake. quite a bit of work but not bad.
Knock Knock - album - was created on 1999-01-12.
Knock First ended on 2004-10-01.
coolant temp. sensor- front of motor on intake manifold intake air temp. sensor- right side of throttle body, on valve cover i believe
Yes
Right above the thermostat housing..
In a very difficult location since there are four. Get the car up on a hoist to do it.
That engine has 2 of them and believe it or NOT. they are UNDERNEATH the intake manifold. You will have to remove the intake to even SEE them are to service them.
In my 01, it's a camshaft sensor under the transfer pump. On some, behind the starter motor in the block. It depends on the year model--get a Haynes manual for your year.
the knock censors are located under the intake. something you need to know when you change the knock censors you need to-take some high temp silicone and build a levee to make the water flow around the censors that is what makes them go bad also check the harness while you have it down
On 01 Daewoo lanos 1.6l USA, the crankshaft position sensor it location on passenger side under car to the rear of a round gear called the crankshaft.it will be very close to this gear but will not be touch it as it uses the "Hall Effect" to detect the position of the crankshaft. This sensor should be location in the same location of all year models of lanos 99-02