where does the hot wire come from going to the distributor on a chevy 350
The distributor should face forward rather than backward on the Chevy 350. It is important to mark the front face of the distributor before removing it.
The distributor and the oil filter.
Yes. Its a direct bolt in.
inside the distributor.
Align the rotor with the number one position on the distributor cap, then with the engine at TDC insert the distributor. There may be a mark on the outside of the distributor to help.
On a small block Chevy the distributor goes through a hole in the intake manifold. On a Pontiac the distributor goes behind the intake manifold.
You can find out in the repair manual for you vehicle.
no that is not possibale because of the lenght of the shaft
When looking down on it: clockwise
try the back of the intake!!
same as a 350
10 degrees advance
turn the distributor
INSIDE the top of the distributor.
Yes it will fit. This distributor will fit all small block and big block Chevrolet engines.