its on the block just below the intake manifold. Everyone knows that! Good luck changing it out, really hard to get to! its on the block just below the intake manifold. Everyone knows that! Good luck changing it out, really hard to get to!
The oil pressure sending unit, on a Chevrolet 4.3 liter V-6 engine, is located on the left side of the engine, just above the oil pan. The sensor is near the front of the engine.
It is in the top back right side of the engine block. you will have to lean up over the engine to see it.
Where is the fuel pressure regulator located on a 1989 chevy silvarado with 5.7 liter engine
The 1994 Ford F3 50 pickup truck 7.3 liter engine oil pressure sending unit can be found on the left-hand side of the engine. The oil pressure sending unit will be near the front of the engine.
Remove the oil pressure sending unit retaining ring. Remove the wiring harness from the sending unit. Poll the sending unit out of the engine.
by the oil filter, under engine.
It does not have a line. It has a oil sending unit on the top right rear corner of the engine block with a electric wire hooked to it. It's about 2 to 3 inches long.
80 lbs
left front of engine
Chrysler didn't have a 5.7L engine in 1999.
The question should read 1989 Ford F250 7.4 liter engine...Location of Oil Pressure sending unit...
If you craw up and lean over the top of the engine and look at the top right rear corner of the engine you will see it. It is just behind the corner of the intake manifold.