answersLogoWhite

Top Answer
User Avatar
Wiki User
Answered 2009-09-11 18:43:56

side of block everyone should have a manual for their vechicle, and the library should have a professional shop manual available in the reference section for FREE to make copies of--the PRO manual has more detailed info, and may have wiring diagrams when needed...read up and fix 'em like a PRO...good luck Dave :) I know that , thought this site was to help with questions,,,,,,,,this is not an answer thank you,,,,,,,,,I looked at the Ford manuel it does not address this problem. so I need help thank you

001
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Your Answer

Related Questions


where is the valve located on the 2002 ranger 4.0 liter 6 cyl?


The oil sending unit is located on the back side of the engine on a 2002 Lancer. It is under the intake manifold.


Behind the A/C compressor on the engine block. 3.0 liter engine


The 2002 Ford Ranger camshaft position sensor is located on the back of the camshaft. The rear engine plate will need to be removed in order to view the sensor.



Temperature Gauge Sending Unit The sending unit is located in the front section of the intake manifold in the vicinity of the thermostat.


Take your 2002 Ford Ranger to the garage to get the engine checked.


follow the top radiator hose to the engine, the thermostat is located in the housing that that end of the hose is connected to



According to the 2002 Ford Ranger owners manual , the inertia switch ( fuel pump shut off switch ) is located in the front passenger footwell by the kick panel


( 4 ) for the 2002 Ford Ranger 2.3 L - DOHC engine


The 2.3 liter DOHC engine in a 2002 Ford Ranger has a TIMING CHAIN


On a 2002 Ford Ranger : The Mass Air Flow Sensor is between the engine air filter and the engine air intake tube


The oil pressure sending unit on a 5.9L V8 is on the top rear of the engine next to the distributor.


I was looking at a picture on fordparts.com for the 2.3 liter DOHC engine in a 2002 Ford Ranger and the water pump is at the very front of the engine , towards the drivers side of the engine


The pump is electric and is located in the fuel tank.



On a 2002 Ford Ranger : The reservoir would be in the engine compartment There are reservoirs for brake fluid , windshield washer fluid , power steering fluid , engine coolant , etcetera


the slave cylander is located in the transmission on the 2002 Ford Ranger. Better see a mechanic to do the job.


where is the camshaft sensors located on Mercedes 2002 1800cc engine


According to the 2002 Ford Ranger Owner Guide : For the 2.3 liter four cylinder engine and the 3.0 liter V6 engine ( 5W-20 ) For the 4.0 liter V6 engine ( 5W-30 )


The oil pressure sending unit is located on the back of the block. it is the sensor located closest to the alternator.


It is located right behind the intake,sticking straight up.If your sitting in your truck look right at the middle of ur windshield it will be located right in that area on the engine.


The firing order for a 2002 ford ranger is 1-3-4-2. The number one cylinder is at the front of the engine.


Where is located the crankshaft sensor in Chevy avalanche 2002 engine 5.3?



Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.