its in the back, between the firewall and the engine. you have to get underneath the car to remove or install it. there are three bolts. 2 from one direction one from the other. the main positive wire from the battery runs to it.
does anything need to be taken off to remove a started on 89 ford probe
Probes were not made until 1989
diagram of starter in a 1993 ford probe
a 99 ford probe doesnt exist
Ford Probe was created in 1989.
how to check the fluid on a manual transmission for a 1989 ford probe gt
Facing your engine, it is on the right side underneath the air intake filter assembly.
The first model year of the Ford Probe ( in North America ) was ( 1989 )
if you have the exhaust manifold, oil lines, etc. from the 89 GT then yes.
where is the ecu located on a 97 ford probe
Open the hood and stand on the driver's side of the car, you should see the transmission. In the top right corner there are two 14MM bolts, your starter is back there, after bolts are removed, reach back there and disconnect the wires from the starter then pull it out. Shouldn't be too hard. Not sure on the automatics though.
where are timing marks on 89 ford probe 4 cylinder I have the bottom not the top