Chevy Blazer
Chevy S-10
Chevy Blazer S-10

Where is the 1 plug located on the distributor for a 93 Chevy Blazer?


Top Answer
User Avatar
Wiki User
2010-09-27 19:58:07
2010-09-27 19:58:07

If you have a 4.3L engine in that 93 Blazer, stand in front with the hood open, looking at the distributor #1 would be at the 5 o'clock position. From that point clockwise it would be 1, 6, 5, 4, 3, 2.

User Avatar

Related Questions

4.3? Follow the spark plug wires from the spark plugs, they will lead you right to the distributor.

On the 4.3L V6 the distributor is located in the back of the engine, in the middle. Just follow the spark plug wires and they will lead you to it.

Assuming this is the 4.3L engine, the distributor cap would be found in the back of the engine on top. All the spark plug wires lead to it.

It is in the very back of the engine. Just follow a plug wire from the spark plug to the distributor cap. It is hard to see. All the plug wires start at the distributor and then hook to each plug.

What engine? V8? 18436572 for chevy 1991 silverado v8 350 diagram

whats the motor.....but regardless if you follow the plug wires they lead to the distributor cap. v6 has 6 plug to each plug and all of the on the distributor cap.......v8 has 8 plugs with their wires leading from each plug to the distributor cap

There is no spark plug cap located on the 1993 Chevy Blazer. The spark plug gap for this vehicle varies depending on the type of spark plug that is used. The OEM spark plug gap for this year is 0.040.

Spark plug gap chevy ls blazer

If you have a 4.3, the 5 plug is the back on the left(Drivers side).

And you still have a skip? Probably a bad injector.

AnswerThe engine oil drain plug is located at the lowest point on the engine oil pan.

It should be located just below the lower radiator hose.

its on the left hand side of the radiator but not very easy to get to My apology, it is a 1996 S10 Chevy Blazer instead of a 1999 Chevy Blazer. I need to see a picture or more detail of where the drain plug is located on the left side of the radiator. I have searched and searched and cannot find anything to drain with. Thanks, Linel

To drain the oil on a 1991 Chevy S10 Blazer, located the oil pan drain plug. Use a wrench to remove the plug and the oil will flow into the receptacle you have provided.

The engine block coolant drain plug on 4.3 liter Chevy Blazer is located on the bottom of the engine, near the oil filter. It allows coolant to be completely drained from the block during maintenance.

The rotor inside the distributor should be pointing at the #1 spark plug.

Distributor cap, rotor, plug wires or spark plugs could do that. Time for a tune up.

plug all wires together.

On the 4.3L it is located next to the thermostat housing. The electrical plug to it has two wires.

Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.