There is a removeable panel below the glovebox. It is in front of the blower motor against the firewall. It has a wire connector from the loom and then it plugs into the blower motor
Most times the resistor is located on the side of the blower motor housing, located under the passenger side dashboard. On some cars,trucks, it is located on the passenger side on the firewall in the engine compartment.
The blower motor speed resistor is burned out. The resistor is located close to the blower motor and is easy to change. Your local auto parts store will have that part for you.
To change the blower motor resistor in a 2002 Nissan Maxima, locate the blower motor resistor under the glove compartment on the passenger side of the vehicle. There is a clip that is depressed and then the resistor will slide out. Remove both ends of the resistor and then replace with the new resistor.
the heater resistor is located under the passenger sides dash (near the passengers feet). there is an access panel that you pull off. some have clips holding it on, some have screws. the blower resistor is located in the blower box. the resistor itself you will not be able to see, only the connector. usually there is about 5 wires on this connector and they are in a row. disconnect the connector, there is usually 1 or 2 screws that hold the resistor in the blower box. remove screws, remove resistor from the blower box. reverse procedure for reassembly. .
You will need to change the blower motor resistor by finding it near the air duct system. You will take the old resistor off and replace it the same way.
How_do_you_replace_a_blower_motor_resistor_in_a_2000_Grand_Am_GT
Please email me a photo of where the blower motor resistor is and how to change it. Thanks, Michael. By the way I want it for a 2000 Sunfire not a Grand Am.
under glove box passenger side
the blower motor resistor should be behind the glove box. just unscrew the two screws and that should be it.
Changing a corsa blower resistor is easy you just have to follow a few steps. First you will have to take the wheels off, and then screw off the caliper, then after screwing off the pads you can replace the corsa blower.
change the blower motor resistor. done deal.
its down under the pass side dash two screws hold it in place and one plug