answersLogoWhite

0

  • Oldsmobile Cutlass
  • Crankshaft Sensors
  • Timing Belts and Chains
  • Ford Ranger XLT

Where is the Crank shaft sensor 1989 cutlass ciera?

User Avatar

Wiki User

βˆ™ 2006-07-22 12:53:11

Best Answer
Copy

Behind the harmonic balancer. You will need to remove the right front tire, remove the access panel to the engine (through the wheel well), remove engine belt, remove harmonic balancer & pulley with a puller. Remove & replace crank sensor, align sensor with an alignment tool, replace balancer with an installer tool.. BE VERY careful with the balancer, the backside of it has a hall effect style blades. bending these blades will junk the balancer.

2006-07-22 12:53:11
This answer is:
πŸ€“
🀯
πŸ€”
User Avatar

Your Answer

Loading...

Related Questions

Why would a 1991 olds cutlass ciera not start after engine gets hot until the engine has cooled off a bit?

I have a 92 cutlass ciera doing that, would run til it got hot, then die...ended up being the crank shaft sensor. hope this helps


Where is the crank shaft sensor located in a Audi a4?

Where is the crank shaft sensor located in a Audi a6


How do you know if your crank shaft sensor is bad?

One symptom of a bad crank shaft sensor is the car having trouble starting. The car stalling and backfiring are other symptoms of a bad crank shaft sensor.


Where is the Crank Sensor in a 2001 Malibu?

The crank sensor on a 2001 Malibu is located on the bottom of the engine near the crank shaft. It monitors the rotation and speed of the crank shaft.


Where is the crank sensor on 89 cutlass ciera?

if engine is 2.8 or 3.1 its on the back side of engine. The only way to see it is from under the car there's a little 4 inch gap between engine and the exhaust manifold. Its up in there. If engine is bigger its near crank shaft pully and harmonic balancer. you may need to remove them to get at it.


How do you replace crank shaft sensor on 2005 Chrysler 2005 300c?

How do you replace crank shaft sensor on 2005 Chrysler 2005 300c?


What is the Location of crank shaft sensor 1992 Chevy truck?

That year model does not have a crank sensor.


Where is the crank sensor located on 1998 Bravada?

the crank sensor is located just behind the crank shaft pully of the engine.


Is the crank shaft sensor part of a tuneup?

No


Where is the crank shaft position sensor on a 1999 Oldsmobile intrigue 3500 engine?

The crank shaft positioning sensor is behind the starter. A real bear to get to.


Where is the crank shaft sensor on a 2000 suburban?

The crank shaft sensor on a 2000 Chevy Suburban is located on the bottom of the engine, near the oil filter. It constantly monitors the crank shaft and updates the vehicle's computer of its status.


Where is the crank shaft sensor in a 1997 sebring convertable?

crank shaft sensor is near the oil filter. I have the repair manual but I am unable to past the page in here.


Where exactly is the 2000 Chevy Impala crank shaft sensor?

install 3.8 Chevy impala crank sensor passenger side , remove wheel and use pully to pull out crank shaft


Where is the crank shaft sensor for a 1989 Chevy van 4.3 liter?

Chevy did not use a crank sensor on that year.


Where do you find the crank shaft position sensor on a 1996 Nissan altima?

Follow the front wire on the distributor and it will lead to the crank shaft position sensor. hope this helps..


Location of crankshaft sensor in 1997 GM suburban?

It does not have a crank shaft sensor.


Can a crank shaft sensor leak oil?

Yes, if it is a sensor that goes into the block.


Diagram of a crank position sensor in a 2002 Nissan Frontier?

location of a crank shaft sensor on a nissan frontier 2002


Where is the location of crank sensor for range rover v8 4.6HSE MODEL 1999?

The 1999 Range Rover 4.6 liter engine crank shaft sensor is located on the back of the engine. The crank shaft sensor is behind the rear engine cover.


I have a Buick la Sabre that wont turn over?

Crank shaft sensor need replaced or cam shaft sensor


Why does your 1996 Lincoln mark VIII have no spark?

ck cam shaft sensor, check crank shaft sensor also.


What is the name of the sensor located by or behind the harmonic balancer?

crank shaft sensor With the limited information you have provided, I would have to say, that you have found the "Crank" sensor.


What does a crank shaft sensor do on a 1998 Honda accord?

A crank shaft position sensor on a 1998 Honda Accord reads whether or not a the engine is spinning correctly. If there is a discrepancy on how the crankshaft is spinning the sensor will relay it to the ECU.


What is a crank shaft sensor?

A Crank Shaft Position Sensor is a magnetic sensor that determines the position of the engine's crankshaft. It is used to set the electronic timing for the car's computer, so it is a very important part of the electronics.


Where is the crank shaft sensor on a 01 Toyota sienna?

Gu