Feedback EGR Sensor The DPFE sensor is a ceramic, capacitive type pressure transducer. The sensor outputs a voltage to the PCM in direct proportion to the pressure drop across the orifice in the EGR pipe. In this way the PCM can make an accurate assessment of the gas flow through the tube. Two different sensors are in use, one metal cased and the other plastic. These sensors should not be interchanged - further, some sensors have a modified voltage output. Sensor view and data: http://www.fordscorpio.co.uk/egrsensors.htm Take a look here, at the diagram, then you should eb able to find it.
Where is the temp sensor on 2000 ford focus zetec engine
P1401 is DPFE sensor circuit high, check out this tutorial to replace the sensor on your Ford
YES - www.motorcraft.com lists a DPFE sensor for all available engines on a 1996 Ford Ranger
Ford is the only American car company that uses a DPFE sensor. GM dpfe sensor are built into the EGR.
Where is the DPFE sensor located in a 1999 Ford Exployer? I had my oil changed yesterday and was told that the hose connected to this sensor is off.
where is the DPFE sensor located on a 2002 ford crown victoria?
A 2000 Ford Focus oxygen sensor diagram can be obtained from most Ford dealerships. The diagram can also be found in most Ford repair manuals.
with the maf sensor
P1405 Ford - DPFE Sensor Circuit Upstream HoseProbably caused by Faulty DPFE sensor (EGR pressure sensor), or a plugged EGR tube
cooling fan not work on ford focus zetec
Where is the coolant temperature sensor on a 2001 ford focus?" Where is the coolant temperature sensor on a 2001 ford focus Where is the coolant temperature sensor on a 2002 ford focus
P0401 means no flow at the dpfe sensor. Usually a bad sensor. or bad hoses from egr ports to dpfe.
According to www.motorcraft.com - YES !
on top of the thermostat housing.
On my 1995 Ford Explorer with the 4.0 liter OHV engine the DPFE sensor ( differential / or delta pressure feedback Egr sensor ) is located on the upper intake manifold on the drivers side of the engine
There are several possible causes of a Ford code 1405. Some of the causes could be DPFE sensor harness short, plugged EGR tube, and or a faulty DPFE.
I'm not a mechanic / technician but I had the DPFE sensor changed on my Ford Explorer . As far as I know it is used to control the amount the Exhaust Gas Recirculation ( EGR ) valve opens
The code P1400 reads "DPFE Sensor Voltage Low" (Ford, Mazda). Often it's caused by a bad DPFE sensor or clogged EGR passages. DPFE stands for (Differential Pressure Feedback EGRI) I would clean the EGR valve which cost nothing. If that does not cure the problem, you may need to replace the DPFE sensor, which does cost, and it may not fix the problem. If you want to be sure you replace the correct part, then visit your local Ford dealer. dpfe stands for delta pressure not differential.
On a single cam ford focus 2000-2001 the cam position sensor is below the pcv valve. If looking at the engine it is on the right side, rear, about a 3inches from the top of the engine.
All that you need to do is unscrew if from the suction side and replace it...........
On the ( 4.0 liter EFI , V6 engine ) the DPFE is on the upper intake manifold on the drivers side of the engine
On the 4.0 L - OHV engine , the DPFE sensor is on the drivers side of the engine , mounted below the idle air control valve
where is the CHT sensor on a 2000 ford F150 where is the CHT sensor on a 2000 ford F150