A2. Per AutoZone.com:: On your 1994 Ford Truck Ranger 2WD (3.0L MFI), the Engine Control Computer is located: Under hood, driver side, rear engine area, driver side of master cylinder, mounted on firewall. All the sensor wires run into a wiring harness, getting progressively larger from Passenger side to the Drivers side ending at the ECC/Ford Ranger. cP GoRS A1. under the hood on the drivers side fire wall, down low near the fender.
no. spline count is different
According to Gates ( they manufacture timing belts ) the 2.3 L engine in a 1994 Ford Ranger is NOT an interference engine
Not 100% positive on the 1994 but a 1992 Ranger XLT 4 cyl has a 16 gallon tank. My 94 supercab holds 18 gallons.
What is a a/cl dv on a 1992 ford ranger xlt vacuum line
How much weight can i pull behind my ford ranger 2000 xlt
how to change a tie rod on a 1992 ford ranger xlt
where is the electronic relay located on a 2000 ford ranger xlt
The electric fuel pump is inside the fuel tank
i was told that it has a 13 gallon tank,,,I have a '94 Ranger 2.3L that has a 20g tank,,,???,,,
how do you change a fuel filter and were is it located on a 2000 xlt ford ranger
extra large turbo
What is the fireing order plug 93 ford ranger xlt 3.0
Remove the valve cover
where is the wire for theft system 2000 ford ranger to bypass
how to replace oil pump in a 1999 ford ranger xlt ext cab 4.0
As far as I know they can not be cleaned. Must be replaced.
i have a 1988 ford ranger xlt 4 cylinder and my spark size is 42-46 hope this will help
where is the temp. sending unit located on a 1999 ford ranger xlt 6cyl 3.0l .Gauge does not work.
yes it would fit in a 1994-2009. some minor duct changes but the engines are dimensionaly the same.
where is the fusible link on a 1996 ford ranger xlt
How to replace a clutch interlock switch on a 1997 Ford Ranger XLT
Bank 1 is the passenger side of a V6 engine in a Ford Ranger
Bank 1 is the passenger side of the V6 engine in a Ford Ranger