Chevy Beretta
Grand Am GT
1982-1994 Chevy Cavaliers

Where is the ECM ignition fuse on a 1988 Chevy Beretta GT?

192021

Top Answer
User Avatar
Wiki User
2005-10-28 03:28:15
2005-10-28 03:28:15

Your ECM should be located on the passenger side of the car. remove the glove box and it should be on the outide wall. I am not sure that there is an acual fuse for this. but that is where the ECM is located. i hope that this is helpful.

1
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions

User Avatar

can someone give me a diagram of a fuse box location for a 1993 Chevy beretta

User Avatar

Due to a over or underloaded system, ensure that the correct rated fuse is installed, over or under amperage can cause a fuse to be blown.

User Avatar

Autozone.com has a fuseblock diagram. Our '93 Beretta is not here for me to go put the fuse block cover on the scanner (fuel delivery problem....), but go look that up. Fuses is called "circuit protection" after you get through all the narrowing it down to 1993 Chevy Beretta Chassis Electrical....

User Avatar

there is a fusable link in the wiring, but no actual fuse. the fusable link is down by the starter assembly...

User Avatar

Two separate items there. There is a horn fuse and a horn relay. Location can be found in the owners manual.

User Avatar

You will often find a diagram of the fuse box for the 1988 Chevy Cheyenne in inside cover for the fuse box. This fuse box is located on the driver's side of the vehicle under the dash. The cigarette lighter fuse is generally marked as ACC.

User Avatar

Look at the panel covering the fuse box.It is either under the hood labeled fuses or under drivers dash.It will be noted what the fuse protects.

User Avatar

There is a fuse for the blower motor on the fuse panel, I do not know of a relay.

User Avatar

There is no fuse for the alternator shown in my factory service manual.

User Avatar

This could be a bad ignition switch, ignition relay, or ignition fuse.

User Avatar

It says on the Fuse Usage Chart: 8. (25 AMP) Heater & Air Conditioner That is the only fuse that mentions the heaters and nothing mentions fans.

User Avatar

Because something on that supply line has a problem

User Avatar

do ya have a picture off a chevy s10 blazer fuse box layout

User Avatar

The fuse for the turn signals is on the fuse block. The fuse block is below the dash to the right of the steering column.

User Avatar

Well the thing is That the car Cranks but I does not start or turn over. I traced it to the 15 amp ignition fuse in the dash fuse box which was broken. I replaced the bad fuse and the Metro started but with in 2 minutes the fuse broke again. I have no clues I have found plenty of clues on -ine but but no answers.Thanks,Metro Owner.Answerbecause a Chevy metro has a 30 amp ignition system. It indicates 15 AMPS on the Fuse Panel!!

User Avatar

The fuse for the radio is in the fuse block, and is marked radio. The fuse block is on the bottom of the dash to the right of the steering column.

User Avatar

There are usually a couple unused "accessory" fuse locations in the fuse block. = will wiring using the "accessory" fuse locations make the power to the device be off when the ignition is off

User Avatar

The 1993 Toyota Camry ignition fuse is located in the fuse box. The ignition fuse will be in the first column, fourth from the top.

User Avatar

The fan relay and its fuse are on the radiator support bracket on the right side of the car.


Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.