1998 Chevy Lumina 3.1L ECM Box Location
I found it on my 1998 Chevy Lumina 3.1 Liter. Car: It is on the right side (Passenger side) of the engine compartment in front the overflow reservoir container and behind Radiator Cap.
It is also under small fuse box.
The ECM is in small black plastic box (about 1.5 Gallons).
You remove the engine right bracket (3 -12 mm bolts) to get to this box then remove two clips on the black box cover... the ECM has two plugged in multi conductor cables. Using nut driver 9/32 th inch (7 mm) to take out these cables .
ECU has part # ID 16236757
Where is the ecm located in a 2000 Chevy Malibu
On my Chevy lumina it is located right by the gas take on the right side of the car.
There is no such thing on Lumina. However if you're talking about the ECM (electronic control module), then you'll need to remove the coolant reservoir. The ECM is located under it.
The Chevy lumina does not have an inertia switch.
The ECM on a 1992 S10 Blazer is located below the glove box.
The trunk release for a 1997 Chevy Lumina is located on the driver side floor. An emergency release is also located inside the trunk.
It is part of the vehicles ECM, which can be found under the hood. It is located on the passengers side all the way in the front right corner. There is a black plastic cover over it.
The Electronic Control Module (ECM)/ Powertrain Control Module (PCM) is located inside the passenger compartment under the dashboard behind the relay panel. Remove the lower trim panel under the glovebox for access to the relay panel and the ECM/PCM.
I think the module is in the distributor with two phillips screws
no ECM's in a 1981
i have a 2001 Chevy lumina and i am wondering if the ECM is going out, sometimes it will die when i am driving but starts right back up, sometimes it will die and not start up after several hours of sitting, then it starts up. Could this be the ECM?
Chevy does not use inertia switches.
I have a 92 lumina 3.4 Mine was above the brake peddle
Simple description: The crank sensor sends information to the ECM so that it knows when to fire the plugs. It is located behind the harmonic balancer. It requires removing the balancer in order to remove and replace it.
Inside the fuel tank.
Behind the glove compartment.
under the dash
Chevy Lumina has not the carborator.
where is my cooling fan relay controll circuit located in a 1997 Chevy lumina, 3.1 engine
There are four motor mounts located on a 1990 Chevy Lumina. Two on either side of the engine. One the rear and one in front of the engine.
In a 1988 Chevy pickup the ECM is located behind the glovebox.
the ecm on this van is on the passenger side behind the plastic kick plate
Where is the computer on a 95 Chevy lumina
in the fuel tank.