Mufflers and Tailpipes
Mitsubishi Eclipse

Where is the ECM on a 1997 Mitsubishi Eclipse Spyder GS?

353637

Top Answer
User Avatar
Wiki User
2009-10-02 17:38:33
2009-10-02 17:38:33
Answer

the ecu is behind the radio in the center console

Answer

the ecu is behind the radio in the center console

exactly show were with pictures
1
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions

User Avatar

It is in the fire wall behind the heater box.

User Avatar

service engine soon you have a problem with your car that your ECM has detected

User Avatar

It is located behind the center console near the ECM. It is large and gold in color

User Avatar

Engine Control Module.............

User Avatar

where is the ecm unit in a 1997 Chevy Malibu 3.1 6 cly

User Avatar

The Engine Control Module (manual transmission), also known as PCM Powertrain COntrol Module (automatic transmission), is located interior under the glove box.

User Avatar

The 1997 Ford Ranger ECM computer is located behind the dashboard. The computer will be on the passenger side of the passenger compartment.

User Avatar

you dont use the ecm, you use one of the wires from the second injector, i think its blue

User Avatar

The Engine Control Module (ECM) probably has to be flashed to relearn the new cluster. This is a job for the Mitsubishi dealer.

User Avatar

Try removing all of the center console parts assuming it is a turbo and has the 4g63t engine if not should be right up bye the battery that big thing with all the heat sinks and plugs in it

User Avatar

change alternater first, then ecm blowed

User Avatar

you will find ECM center front (inside car ) on the floor hide by black plastic.

User Avatar

ECM will not cause A/C to not work properly. some of the earlier mitsubishi's had a ground wire for the A/C going through the ECM. and i have ran into the circuit in the ECM that grounds it go out causing the A/C to not work on a few diffrent cars

User Avatar

There is no such thing. The pump runs off a relay. There is a fuel pump shut off relay. If the ecm sees a fault in the system, it will shut off the pump to prevent damage or fire.

User Avatar

Just unhook the battery cables for 5 mins, That will reset the ECM

User Avatar

i am afraid this question you need vin # ,engine size, AT, and possibly a trip to the Mitsubishi dealer. I have had luck at a GOOD junk yard with getting an ecm that works in my vehicle even though the #'s off old ecm are not exactly the same. If you can get the old ecm out take it with you to the junk yard and see if they can match it. Also there is a place in Florida that repairs your ecm and sends it back to you. Do a Google search and you should be able to find them.

User Avatar

Either replace the engine ECM or have the existing one reflashed with new parameters.

User Avatar

the library should have a shop manual for this vehicle, you can make copies of the right sections :)

User Avatar

It is under the dash, in back of the glove box.

User Avatar

Should be under the hood on the pasenger side.


Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.