Asked in Car Stalling Problems
What causes the 1999 jeep grand Cherokee to stall.it stalls hot or cold winter of summer.?
There are a couple of reasons why a 1999 Jeep Grand Cherokee may stall in any weather condition. One reason could be the ECU computer could be going bad. ...
Where is the ecu located in a 2000 Jeep Grand Cherokee Laredo?
On the right hand (passenger) side of the engine compartment towards the rear on the firewall. ...
Asked in Jeep Grand Cherokee Laredo
Where is the ECU of a 1993 jeep grand Cherokee Laredo located and How do I take replace it?
in the engine compartment on the firewall right in front of the passenger and right behind the coolant bottle. ...
Asked in Jeep Grand Cherokee, Jeep Grand Cherokee Laredo, Jeep Grand Cherokee Limited, Miscellaneous Vehicles
Where is the ECU located in a 1997 jeep grand Cherokee limited?
I have a 1998 XJ. The ECU is located in the engine compartment, toward the front, mounted on the driver side. It is a flat aluminum piece about 3/4 inch thick with three (I think) plugs on the side. ...
Where would a 1995 Jeep Cherokee computer brain be?
i dont know for sure that the 1995 is the same but, on my 1991, and on the 1992 cherokees the computer (ECU) is on the drivers side inner fender behind the air box ...
Where the ecu chip located in a 1999 Mazda protege will it help your stalling in second gear problem?
how do ecu chips work how do ecu chips work
Asked in Jeep Cherokee
What does it mean when the check engine light comes on for a 2000 Jeep Cherokee?
Something is effecting the emissions system. There is a fault code stored in the ECU which can be accessed with an OBD2 scan tool. With this code a qualified technician can determine the cause of the problem. ...
Asked in Subaru Forester
Where is the ECU and ECM modules located in a 1999 Subaru forester?
The ECU in a MY 1999 Subaru Forester is located at the upper left site of the engine under the air intake. ...
Asked in Cars & Vehicles, Jeep Grand Cherokee
How do I reset P1494 code on 1998 Jeep Grand Cherokee?
You have a problem with the EVAP Leak Detection Pump. You must first repair the problem that caused the ECU to set this code. Once the problem is repaired the code can be reset with an OBD2 scanner. ...
Asked in Jeep
How do I reset a Jeep Cherokee 2007 alarm?
It takes a special computer program that can plug into cars diag port and input to ECU. An auto locksmith can do it on a laptop in about 10 mins. Look under services on Craigs for one that is mobile, should be about 100.00 (approx) ...
Asked in Jeep Wrangler Rubicon
Government speed chips control on my jeep rubicon 2003?
Jeep isn't a speed machine anyway but it is stored in the ECU and can be raised faster than your Jeep can go by an aftermarket (superchips/hypertech) programmer. ...
Asked in Jeep Grand Cherokee
If you were to change your electric speedometerThe Whole Clusterin a 1997 Jeep Grand Cherokee would the mileage stay the same or stay with the old speedometer and change to what the new one is?
It will the same mileage of the new cluster you installed. mileage recorded on the cluster not on the ECU I'm sure about this 100% It will the same mileage of the new cluster you installed. mileage recorded on the cluster not on the ECU I'm sure about this 100% It will the same mileage of the new cluster you installed. mileage recorded on the cluster not on the ECU I'm sure about this 100% ...
Asked in Jeep
Does a Jeep High Output 4.0 motor require a different ECU than a regular jeep 4.0?
Yes. The flash programing is different in the module. That is the only difference.They are identitical in appearance. ...