Best Answer

The 1989 Mercury Sable 3.0 liter engine EGR valve is located on the firewall. The valve will be on the passenger side of the firewall.

User Avatar

Wiki User

โˆ™ 2014-09-18 00:22:39
This answer is:
User Avatar

Add your answer:

Earn +5 pts
Q: Where is the EGR Valve located on a 1989 Mercury Sable 3.0?
Write your answer...

Related Questions

Where is the turn signal relay located for a 1989 Mercury Sable?

where is turn signal relay located at 1989 mercury sable

When change your 1989 Mercury Sable timing belt?

In a 1989 Mercury Sable : Both the 3.0 and the 3.8 litre V6 engines have a timing CHAIN

How large is the fuel tank in an 1989 Mercury Sable?

According to my Chilton's Auto Repair Manual : For a 1989 Mercury Sable : ( 16.0 U.S. gallons , or the optional extended range tank which is 18.6 )

Can you get A diagram of PCV valve location in 1989 through 1999 Mercury Grand Marquis?

Yes, a person can get a diagram of the PCV valve location in a 1989-1999 Mercury Grand Marquis. This diagram would be located in the maintenance books found in auto part stores.

Is battery ground pos or neg on 1989 mercury sable wagon?

The ground is negative

Where is the PCV valve located on 1989 Mitsubishi Montero?

It is in the valve cover.

How do you install a CD player in 1989 mercury sable?

Drivers side on the frame paralle to the tranny , you have to get it from underneath..

Where would the fuel filter be located in a 1989 Mercury Sable?

Check under the hood by the right shock absorber tower or along the frame rail under the car towards to rear

Where would the starter be located in a 1989 Mercury Sable?

The starter is located at the front of the engine (front of the car). Look at the engine from underneath, just behind the radiator - follow the heavy gauge black wire to the starter itself.

Where is the amplifier in a Mercury Cougar located?

Where is the radio amplifier in a 1989 mercury couger

Location of PCV valve 1989 camaro?

The pcv valve on a 1989 Camaro is located in the top of the valve cover. It plugs into a rubber grommet and is easily replaceable.

Where is the EGR valve located on a 87 Mazda B2200?

where is the EGR valve on a 1989 mazda b2200

Where is the PCV valve located on a 1989 Honda Accord SEI?

Not sure about the 1989, but 1990-1993 it goes into the valve cover. Look for a hose running to the valve cover and the PCV valve should be what is at the end of it pushed into the valve cover.

Where is the PCV valve located on a 1989 G20 5.7L?

remove cowling it is on the passenger side valve cover

Is a 1990 Ford Taurus back window compatible with a 1989 mercury sable?

Usually that would be the case, however their are variations in both cars.

Where is the EGR valve located on a 1989 Jeep Wrangler 4.2?

Looking at the front of the motor, the egr valve is located on the right lower side of the carburetor.

Where is the EGR valve on 89 s10?

The Exhaust Gas Recirculation Valve on a 1989 S10 is located in the valve cover. It is toward the front of the motor.

Where is the ERG valve located on a 1989 Dodge Ram?

If you're standing in front of your vehicle the EGR valve is located on the right side of your carb, below the breather.

Where is EGR valve located on a 1989 chev camaro 350?

intake manifold

What would cause a battery to drain in a 1989 mercury sable if it is not the power cords or alternator?

dead cell in the battery or something is on pulling power from the battery.

Where is the EGR vavle located in a 1989 corvette?

The EGR valve is usually located on the top of the valve is usually a plastic part that connects to the valve cover with a rubber seal...there is an emissions hose leading away from it...the PCV valve is also located on the valve cover in a similar fashion, though it is a lot smaller...

Where is located the ignition module in a mercury tracer 1989?

ignition control module is located under the distributor cap

Where is the head gasket located on a 1989 Mercury Topaz?

Have to take off the head, it's there.

What is the spark plug gap for a 1989 Mercury Sable?

Listed in the owner's manual and under the hood on a placard. Also the parts store where you buy the plugs can supply this info.

What could be the reason for dash board lights and tail lights not working on a 1989 Mercury Sable even after the fuses have been replaced?

Is there a penny stuck in the lighter port?