I own a 2002 Mazda Protege5 with the FS2.0 Motor. The EGR Valve is located below the throttle-body. You must take off the Intake tube to get a good view of it. To replace it I think you might have to take off the throttle-body, but I'm not sure about that...(yet)
NOTE: Mazda put out a technical note stating that "if your car has sat for a long time, the egr valve could be damaged by moisture (rain) and will need to be replaced". My 2002 Protege sat for 3 weeks and the rain caused this exact issue and had to be replaced. How did I know? The engine light came on (after never coming on) and the car had an extremely rough idle. Total cost was ~$400 (ouch).
Where is the EGR Valve on a 1996 Mazda Protege located at?
Were is the egr on a 1992 mazda protege
how much does it cost to replace to egr valve on the 2002 mazda protege
Were is the egr valve on a 99 Mazda progege 1.8
The EGR valve is connected above the water hose on the 2002 Mazda Millennia. The EGR valve is responsible for lowering the temperature of the fuel.
It should be underneath the throttle body on the back of the intake manifold
It's bolted right on top of the egr valve which is on the back of the engine under the throttle body there will be a small vacuum line going into where the egr valve bolts into the intake
where is the EGR valve on a 1989 mazda b2200
The EGR is right under the throttle body. It has like a little black top. You have to remove the intake hose to see it. Its a pain to get to and remove.
The egr position sensor is made into the egr valve. Look for the egr valve and you will find a plug with wires plugged into the egr valve. These wires are for the position sensor and they go back to the ecm ( engine control monitor)< computer> James= 15 year Mazda tech just a tip= with engine COLD,reach under valve and press on plunger and see if it moves freely(not easy) but freely. Hope this helps.
There is no egr valve on a 1990 Mazda MPV 6 cylinder
Remove the vacuum line than attach it to the EGR. With the valve open and lifted, suck on the line and spray on the valve. You should also have a new gasket to replace the existing one. Check all the hose connections
9 times out of 10 is a your EGR valve stuck open due to rust, do a google search for protege low idle you'll find it! good luck
Remove the air breather and its underneath.
The 2002 Mercury Mountaineer EGR valve can be found in the engine compartment, on the firewall. The EGR valve will be labeled as such.
It happened to me last week. Turned out to be the EGR valve that was not moving anymore. This valve is used when the motor is in idle which is why the motor was running almost fine when I was putting gas...
I Called the Mazda dealer today and talked with the Mazda Tech and asked him the location of the EGR valve on the 1992 Mazda b2600i. According to the tech only the California models have an EGR valve, I would think that any state with similar laws about vehicle emmisions would require the egr valve also. My truck is from Montana and it doesn't have an egr valve which explaines why I havent been able to find it.
its not a leak by the egr but a leak in it..... you need a new egr and gasket. hope that helps
The EGR valve is located at the right rear corner of the intake manifold, near the firewall. before unbolting the EGR valve, disconnect the vacuum line. - Mazda Repair Manual
There is no EGR valve on the 2002 4.3L (code W)
It is located under the trottle body. Milt
An EGR valve usually can't be cleaned. If you want to try to clean it, us Combustion Chamber Cleaner on it. If this doesn't work then the cost of an EGR Valve from the dealer is about $275.00 Can. I have had to replace my EGR valve about 2 months ago and I wasn't able to find an after market replacement.
The 2002 4.3L has an EGR valve, at least mine does.
The 2002 Grand Vitara EGR valve is located on top of the engine. The EGR valve will be between the engine and the battery.