Mercury Cougar

Where is the IAT located on a 2001 Mercury Cougar?

414243

Top Answer
User Avatar
Wiki User
2005-09-28 15:34:23
2005-09-28 15:34:23

it's on air box , where the air filter. you have to turn couterclockwise to remove it.

1
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions

User Avatar

The IAT sensor on a 2000 Mercury Cougar V6 is on the back side of the filter box. On the Zetec model it is either on the Air box like the V6, or on the intake tubing running from the box to the Throttle Body.

User Avatar

it's located on the firewall right in back of the intake

User Avatar

Yes, there is an intake air temperature (IAT) sensor in a 99 coug. The IAT is located by the mass air flow sensor between the air fliter and the intake manifold.

User Avatar

Located in the air intake tube beside the battery.

User Avatar

I need to locate the IAT sensor on my 2001 Aurora

User Avatar

The IAT is located in the air intake tube before the MAF.

User Avatar

The iat is the two wire sensor on the front passenger side of the intake manifold.

User Avatar

From what I understand looking on forums and such, is the IAT is integrated into the MAP sensor. It should be located on the top of the intake manifold.

User Avatar

Its integrated into the MAF sensor as of 1998.

User Avatar

The IAT is part of the MAP sensor on vans before 2001. In 2001 they started putting it near the air box.

User Avatar

The IAT sensor is in the intake air duct

User Avatar

They are located on the IAT itself which is on the throttle body

User Avatar

the iat is located on the intake just before the throttle plate

User Avatar

IAT sensors are usually located in the intake elbow. Have a pig tail connector and look like a loop with a probe inside of it once you unthread it. Actually on 2001 and later model V6 Mustangs the IAT is integrated into the MAF. If you look at the MAF on a 2000 and earlier it is a 4 pin. Where as 2001 and later it is a 6 pin. Those two additional wires run to the IAT. On 2000 and earlier the IAT is a small probe that is before the MAF, that is placed directly into the intake tube.

User Avatar

It is the intake air temperature sensor , and it,s located in the air intake boot.

User Avatar

The IAT sensor is located on the air box. Team Clockwork Performance

User Avatar

The IAT sensor is located in the intake manifold

User Avatar

Generally the IAT only has two wires going to it. The IAT is just a temperature dependent resistor.

User Avatar

The intake air temperature(IAT) sensor is located in the air cleaner box. this vhicle uses a combionation IAT /MAF(mass air flow) sensor. 6 wires are connected to it.

User Avatar

The iat sensor is also known as the mat sensor which is the manifold air tempeture. it is located on the front of the intake manifold. its a 2wire gray plug

User Avatar

Intake Air Temp Sensor It should be located on the intake or close to the throttle body

User Avatar

It's part of the MAP sensor, mounts on left side of intake.

User Avatar

intake air temp sensor is located on the air filter box lid.


Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.