Car Computers and Sensors
Hyundai

Where is the IAT sensor located on 2006 Hyundai Tuscon 4 cylinders?

345

Top Answer
User Avatar
Wiki User
Answered
2009-11-24 22:02:48
2009-11-24 22:02:48

The sensor should be located on the intake boot(air intake system) or on the intake manifold.

001
๐ŸŽƒ
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0
User Avatar

Related Questions


Where is IAT sensor is located for Hyundai Sonata 2002 base 2.4Liters 4 Cylinders?


where is the coolant temp sensor located on a 2006 hyundai sonata


A crankshaft sensor, on a Hyundai XG350, can be installed by simply plugging the new sensor into the slot of the old sensor. The sensor can be located on the back of the engine cover.


The Hyundai Sonata's transmission range sensor is located directly below the vehicle's oil filter. It is located near the range switch.


The EGR temperature sensor is located in the intake manifold between cylinders 3 and 4


where is the crank position sensor located on a 2004 hyundai v-6 2.7 engine


IAT - Intake(or incomming) air temperature sensor. It will be located along the air intake tube. It is usually either on the airbox or right after. Before you get to the mass airflow sensor. It usually just is held in the tube by a grommet. Undo the connector and pull it out.



in the exhaust pipe some maybe in the exhaust manifold for 4 cylinders


Bank 2 Sensor 2 PO160 on a 03 Hyundai Santa Fe


The IAT sensor on a 1997 Hyundai Accent is found in the piping for the intake system. The sensor will be plugged and mounted near the air box for the air filter.


The 2007 Hyundai IAT sensor can be found connected to the air intake hose. The sensor will be between the air filter box and the top of the engine.


The upstream heated oxygen sensor is located ahead of the catalytic converter The downstream heated oxygen sensor is located behind the converter


The upstream heated oxygen sensor is located ahead of the catalytic converter The downstream heated oxygen sensor is located behind the converter


The upstream heated oxygen sensor is located ahead of the catalytic converter The downstream heated oxygen sensor is located behind the converter


in front of the motor by the transmission


The VSS:Vehicle Speed Sensor is located on the transaxle



The crankshaft position sensor is located on the front side of the engine block near the flywheel/driveplate


The upstream heated oxygen sensor is located ahead of the catalytic converter The downstream heated oxygen sensor is located behind the converter


THE AUTOMATIC TRANS OIL TEMP SENSOR IS LOCATED ON THE A/T VALVE BODY BEHIND THE PAN.


The Cam sensor is located at the right rear corner of the cylinder head


The TBS or "throttle position" sensor is located near the throttle body on the linkage.


Crank Angle Sensor (location)i own a 98 Hyundai accent and the crankshaft position sensor is located just underneath the far right spark plug if your looking from the front of the car,about 5"-8". hope this helps.


Bank 1 would be the bank of cylinders that contain cylinder number 1. Bank 1 on the 3.9 would be the bank of cylinders located on the drivers side of the engine. Bank 1 sensor 2 would be the O2 sensor located after the catalytic converter.



Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.