Chevy Silverado
BMW 3-Series
Dodge Ram
Late Model 1979-New Ford Mustangs

Where is the IAT sensor located on a 1988 Ford Mustang 5.0L?

789

Top Answer
User Avatar
Wiki User
2010-01-25 07:25:19
2010-01-25 07:25:19

not to be mean but fords dont have iat sensors they have a map sensor and it is located in the intake tube between the throttle body and the air filter

WRONG!!! The IAT sensor, or the air change temp sensor is located on the right side of the lower intake, right behind the the very first injector on that side.

1
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions

User Avatar

The camshaft position sensor on a 2001 ford mustang is located on the front of the engine. It is behind the power steering fluid reservoir.

User Avatar

I think you mean CAMSHAFT position sensor.

User Avatar

Bank 1 is the passenger side of the engine on your Ford Mustang Sensor 2 is in the exhaust after the catalytic converter ( downstream )

User Avatar

Bank 2 is the driver's side of the engine in your Ford Mustang Sensor 2 is in the exhaust after the catalytic converter ( downstream )

User Avatar

I don't know if it is the same as the Ford Mustang , but the BAP sensor was mounted on the firewall - good luck

User Avatar

The horsepower in the 1988 Ford Mustang 5.0 was 225 horsepower

User Avatar

I believe it is mounted on the firewall , just to the right of center

User Avatar

In front of the catalytic converter on the passenger side

User Avatar

On a Ford Mustang ( V6 and V8 ) Bank 1 is the passenger side of the engine

User Avatar

Behind the glovebox compartment and radio area.

User Avatar

Either at the bottom or rear of the radiator

User Avatar

where is the cylinder temp sensor on a 2002 ford mustang six cylinder

User Avatar

Bank 1 on ford is on passenger side.....the side with cylider 1 has bank 1

User Avatar

I don't think a Mustang has a MAP sensor. They are MAF system.

User Avatar

On a 2001 Ford Mustang , 3.8 liter V6 engine : Bank 1 is the passenger side of the engine Sensor 1 would be close to the engine BEFORE the exhaust enters the catalytic converter

User Avatar

where is the CHT sensor on a 2000 ford F150 where is the CHT sensor on a 2000 ford F150

User Avatar

The IAT (Intake Air Temperature) sensor is an integral part of the Mass Air Flow (MAF) sensor.

User Avatar

220 horsepower for the high output 302 in a 1988 Ford Mustang

User Avatar

The horn are located in the driver side front fender

User Avatar

There are two,they are located on top and near the front of each valve cover

User Avatar

On a Ford Mustang ( V6 and V8 engines ) Bank 2 is the drivers side of the engine Sensor 2 would be AFTER the exhaust has passed through the catalytic converter

User Avatar

The IAT sensor is an integral part of the MAF sensor

User Avatar

where is the intake air charge temp. sensor on a 1991 ford 5.0 coupe mustang

User Avatar

The timing specs for a 1988 Ford Mustang 2.3L can be found in the service manual for this vehicle. You can find this at many libraries as well as at a Ford dealership.


Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.