answersLogoWhite

0


Best Answer

It is in the same housing with the MAF by the air filter box.

User Avatar

Wiki User

โˆ™ 2004-12-29 06:23:36
This answer is:
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
User Avatar
Study guides
๐Ÿ““
See all Study Guides
โœ๏ธ
Create a Study Guide

Add your answer:

Earn +20 pts
Q: Where is the IAT sensor on a 1997 Dodge Avenger 2.0 L 5-speed?
Write your answer...
Submit
Related questions

Where is the bank 1 sensor 2 oxygen sensor on a 1997 dodge avenger?

It is the sensor below the catalytic converter.


Is the cam position sensor on a 1997 dodge avenger located in the distributor?

On the v6, yes.


Where is the location for the downstream oxygen sensor on a 1997 Dodge Avenger?

Downstream O2s are on the outlet side of the catalytic converter(s).


Will a bad cam sensor stop your 1997 dodge avenger 2.0 from starting?

It could, along with numerous other things.


Where can you find a schematic for the IAT sensor on a 1997 Dodge Avenger 2.0 L 5-speed?

Check out a good Public Library.


1997 Dodge Avenger oil type?

5w30


Is it an electronic transmission in the 1997 dodge avenger?

Yes


What coolant is recommended for a 1997 dodge avenger?

Green


Where is the oxygen sensor on a 1997 Dodge turbo 3500 5.9 Cummins diesel?

A 1997 Dodge with a Cummins diesel does not have an oxygen sensor.A 1997 Dodge with a Cummins diesel does not have an oxygen sensor.


Where is the reset switch for a 1997 dodge avenger?

Dodge does not use inertia/reset switches.


Does the fuel pump on a 1997 Dodge Avenger have a reset button?

No


What is the bolt pattern on a 1997 dodge avenger?

5-114.3


Where is cabin filter on 1997 dodge avenger?

Not equipped with one.


Diagram of where the cam sensor is on a 1997 dodge avenger?

It is located inside the distributor. It is not servicable, There are little pins inside that a easily broken if you try to replace it yourself.


1997 Dodge avenger where is the fuel pump shutoff?

If you are looking for a reset switch, Dodge does not use them.


Where is the governor pressure sensor or rev limiter located on a 1997 Dodge Avenger with a 2.0 4cly?

It doesn't have a governor pressure sensor. The "rev" limiter is part of the computer programming and can not be changed.


Does a 1997 dodge avenger bend valves when a timing belt brakes?

It can.


What should the compression be on a 1997 dodge avenger?

125 psi approximately.


Is the starter relay for a 1996 and 1997 Dodge avenger located in the same place?

The starter relay switch is in the same location on both the 1996 and the 1997 Dodge Avenger. The starter relay switch can be found in the fuse box.


Where is the filler drain on a 97 Dodge Avenger manual transmission?

The drain fill on a 1997 Dodge Avenger manual transmission is on the bottom of the transmission. It is located up from the drain plug.


What size bolt holds on a harmonic balancer for a 1997 dodge avenger?

22mm


How do you replace EGR valve or clean it on 1997 Dodge Avenger?

Replace if failed.


Oil capacity with filter on a 1997 dodge avenger 2.5?

4.5 quarts


Where is the crankshaft position sensor located on a 1997 Dodge Avenger?

depending on engine size it could be in 4 different places. 2.5 liter is behind cruise control actuator.


Where on a 1997 Dodge Dakota with a 2.5 liter engine is the mass air flow sensor?

There is not a mass air flow sensor on a 1997 Dodge Dakota.