On top of the intake manifold. #20 on this image.
SAE 5W-20 is recommended for a 2005 Mazda3.
Most vehicles do not have an IAT sensor. there is a scam on eBay right now trying to get people to buy a "Chip" that well give ur car 20+ horsepower. these 2 wires are nothing but radioshack resistors. Almost everycar has a MAF (mass air flow) indicator, not an IAT, so therefore the chip does not work, and u can not send it back or get a refund.
it's on top of the engine close to where the thermostat is.it does have two wires 18 or 20 ga.
is located in the intake is a two wire sensor is really hard to miss is located in the intake is a two wire sensor is really hard to miss ________________________________________________ The IAT is built into the MAF sensor right after the filter box. Source: http://dutch.northwestmr2.com/Toyota/mr2%20spyder/Repair%20Information/New%20Car%20Features/03%20-%20Engine%20and%20Engine%20Control/12.pdf
The EPA mileage estimate for the 2005 Mazda MX-5-Miata is 20 mpg in the city, 26 mpg on the highway.
The cam sensor is located on the left side of the engine (as your looking at it) on the valve cover. It is the only sensor that is located on that side on the upper part of the engine.
1. The Mazda three did not exist in 1995 2. The coolant temperature sensor is probably bad
can 20 " RIMS FIT ON A MAZDA 626?
Behind the throttle body opening under the throttle position sensor. Takes Torx t-20 bit to remove -- 2 screws, use Torx bit on a 1/4" socket drive with a 1/4" socket to break seal on Torx screws.
Martha - 2005 2005-12-20 was released on: USA: 20 December 2005
Brunch - 2005 2005-10-20 was released on: USA: 20 October 2005