I am the person who originally asked this question yesterday. After looking through the web for insight I narrowed it down to were it would be myself. So I can answer my own question now. It's the 2 wired plug thing coming out of the upper right side of the airbox. NOT the 3 wired rectangle on the intake tube between the air box and throttle body.
iat sensor on a 97 blazer and what does it do
The IAT sensor for a 97 Ram 2500 is on top of the engine. It is at the front on the passenger side of the intake.
The IAT sensor can be found on the top of the engine. The sensor will be near the fuel injector rail. The sensor should be labeled as such.
The IAT on a 94-97 models is not a separate component, like on later models. It is included in the Mass Air Flow Sensor. The Mass Air Flow Sensor is the black, plastic tubular component connected at the top of your airbox on the driver's side.
the intake air temp sensor is in the inlet manifold
its in the back wheel under the rotator splint
The "Check engine" light will illuminate and a code will set.
The intake air temperature (IAT) sensor of the 1997 Hyundai Sonata is located in the air hose assembly. Follow the air hose to the immediate entrance to the air filter box and that is where to find the IAT wiring harness.
try lookin under the rear seat
No, you'll need an intake hose for either a 97 or 98
where is fuse for 97 Mazda protege ? and other fuses for headlights cause they don't come on help ?
On the front passenger side corner of the intake. It has two wires.
It should be in the air boot between the air filter box and throttle body (it is a two wire sensor)
Be sure to check the wires going to the IAT sensor. Nissan used cheap wiring for this and it usually breaks. The problem is the wires constantly flex when the engine moves.
Never mind, got it from all-data, BTW the haynes book is totaly wrong, what a surprise.
you need to change the input turbine speed sensor
Replacing the 1997 Mazda water pump will cost approximately $300. The water pump will cost about $75 and will require four hours of labor.
there is not one. You must turn the heater on and take radiator cap off. Of course car must be running.
Hey Jose==It is in the exhaust pipe. GoodluckJoe
Trouble code P0134 means:O2 sensor circuit no activity detected (Bank 1 Sensor 1)
JUST TO THE RIGHT OF THROTLE RETURN SPRING IT IS A 2 PIN PLUG.
Use SAE 10w30 conventional or synthetic. Use a High Mileage oil if the odometer reads over 100,000 miles.
I am having the same problem with a 99 Protege. I have changed the alternator and aligned/cleaned the pulleys and the problem persists.I replaced the alternator, on my 1997 Mazda Protege, seven times before someone figured out why the serpentine belt kept breaking. It was the belt tensioner! It had to be removed and rebuilt. Now it is working like a charm!! And I havn't had to replace the alternator in over 3 months!!!!
starter on a 1.5 is located on rear of block under intake manifold. 3 bolts hold it in place ..2 are accessed from top of engine and third is accessed from below.
where is the oil sensor on a 97 gmc jimmy