the o2 sensor for a 1990 Chevy Lumina euro 3.1l v6 is on the down pipe for the exaust just below the manifold on the back side of the engine, by the firewall
Should be by the alternator in the back
How do you replace the blower motor on a 1994 chevy lumina euro?
There is no cable....It's all done with a sensor and electronics.
It is on the throttle plate opposite of the bellcrank.
With a pry bar in the right spot and some leverage it will pop out.
access panele under saet of 1990 luminu euro
Yes it will, I did the interchange on mine
There is no cam sensor on a 93 3.1. Just a crankshaft sensor....which is located behind the harmonic balancer. WRONG! it does in Fact have a cam position sensor! its underneath the intake plenum!
Well, I have a 1990 Lumina Euro, 4 door and it has a 3.1 in it. Yours should have the engine size on the block. Mine does. Just pop the hood and look on top. :o)
After removing axle from steering knuckle you can pop it out of tranny with a pry bar.
If its like the 1993 Lumina it's in the fuel tank.
where is the fuel pressure regulator on1991 lumina 3.1 /
Depends on it's condition, mileage, options, and where you live. Go here: www.nada.com to find out.
I belive it is somewhere on the transmission, *I just replaced the speed sensor on my 93 Chevy Lumina Euro so look on the passenger side right below the alternator on the transmission. One bolt to unfasten, then lift out. Solved our problem of erratic movement of speedometer needle and changes in speed of cruise control, also slowness in accelerating after stopping.
I doubt it
It's called the tunk lip!
your firing order is 165432
Did u check under the driver door.
remove bolts and replace it how do u think
my 93 lumina was cutting out and i cahnged the fuel filter and spark plugs and it runs good
I have a 93 euro 3.1 with 186k and am getting between 20 and 25 depending on how I drive.
Ticking in an engine generally refers to the valves. If ticking is apparent on a 1994 Chevy Lumina tighten the valves to factory specifications.
It can be successfully cleaned with Carb' cleaner and a soft brass brush. I also flushed areas I couldn't reach with the brush.
Have them repaired or replaced ASAP. If you had to make an evasive move you could lose control of the vehicle.
Because you have a leak.