answersLogoWhite
Oxygen Sensors
Chevy Malibu
1982-1994 Chevy Cavaliers
1995-2005 Chevy Cavaliers

Where is the O2 sensor located on a 1993 Chevy Cavalier?

456

Top Answer
User Avatar
Wiki User
Answered
2006-07-02 01:59:01
2006-07-02 01:59:01

It is located either on the manifold or somewhere on the exaust

001
๐Ÿฆƒ
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions


The knock sensor for the 1993 Chevy Cavalier is located in the back of the motor. It can also be located in the engine valve.


The crankshaft sensor is located on the side of the motor towards the firewall. It is located more towards the oil filter,


i need to find location of fuel filter on 1993 Chevy cavalier


Its located up and alittle to the right of coil packs on back side of block


The fuel pump is located in the gas tank.


The neutral safety switch, on your 1993 Chevy Cavalier, is located beneath the shifting column. The switch can be accessed by removing the shifting boot.



That year did not have a crank sensor on it.


GM vehicles are not equipped with an inertia switch.


The sensors are located on the transfercase for your cluster panel


1993 Chevy cavalier 2.2l Spark gap is....................... 1.4mm


The fuel level sensor would be located in the fuel tank.


The VSS sensor is the vehicle speed sensor and it is located in the transmission. The purpose of it is to operate the speedometer and abs system.



Assuming that it is a 3.1 V6, as most of them are, there is no cam sensor. Only a crankshaft sensor. It is located behind the harmonic balancer. To replace it the balancer has to be removed.


The fuel filter on a 1993 Cavalier is located and the rear of the vehicle on the passenger side. If you slide up underneath the car, you will see it coming off of the fuel tank. Hope that helps! It is located right behind the gas tank on the passenger side. That is if it is a z24


It is in the driverside head between the front 2 spark plugs.


Either before or after y pipe, or both, depends.


It's in the rear of the engine not the front. It's hard to see but it's tucked up there.


The crankshaft position sensor is located on the rear of the engine. It is mounted just above the oil pan on the engine block.


its located behind tbi and next to distributor mounted in the intake manifold


There is no cam sensor on a 93 3.1. Just a crankshaft sensor....which is located behind the harmonic balancer. WRONG! it does in Fact have a cam position sensor! its underneath the intake plenum!


where is the crankshaft sensor located on a 1993 dodge intrepid


Where is the horn located on a 1993 chevy blazer




Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.