Where is the OBD1 connector for a 96 Southwind class A motor home with 7.4 Ford motor?

Blown fuse, defective blower motor resistor pack, blower motor, or blower motor switch. This happened to me and I found a connector at the fan motor had fried. I changed the connector and it worked great.

Disconnect the fan motor electrical connector. Unbolt the fan bracket and shroud assembly. Take the harness connector from the shroud. Lift the shroud out of the engine compartment. To separate the fan from the motor take loose the motor shaft clip. Remove the bracket from the fan motor by detatching the harness from the retainers then remove the mounting screws.

Henry Ford - Creator of the Ford Motor Company. Henry Ford - Creator of the Ford Motor Company. Henry Ford - Creator of the Ford Motor Company. Henry Ford - Creator of the Ford Motor Company. Henry Ford - Creator of the Ford Motor Company. Henry Ford - Creator of the Ford Motor Company.

The Ford F450 OBD connector can be found on the top of the engine. The ODB connector will be near the air intake housing.

On the 5.4 the knock sensor is under the intake and the connector is in the back of the motor on the passenger side.

On a 1995 Ford Econoline E350, the resistor is located to the right of the blower motor in the engine compartment. It is the second plug attached to the blower motor wiring harness. It has two screws and a white connector compared to the black one for the blower motor.

by the blower motor there is a resistor connection, you will find it melted the blower motor is bad. it draws to much power causing the connection to get hot and melt and burn. you will have to change the connector and the blower motor. the blower is still working but its drawing to much power, the motor windings are shorted out inside. disconnect the connector from the resistor and you will see it.

The Ford 460 CUID is a reliable motor, but you won't be passing too many gas stations.

this resistor is located next to the blower motor in the heater plenum. the coils sit in the air stream. remove the connector and the fasteners and pull the resistor block out.

It could be the motor, switch, relay, corroded or dirty connector, damaged wire or blown fuse.

you have left a small lead with a female connector off the starter motor solonoid

i have a 99 ford ranger xlt. my code scanner connector is not working,is there a fuse for it

If it's anything like my girlfriends 2007, its underneath the glovebox. It's held in place by 3 screws and a wiring connector.

Ford Motor Company is a self-owned company. Current Chairman of the Ford Motor Company is William Clay Ford, Jr.

Ford never made a 350 motor

what was the cost of ford motor stock in 1971?

what are the demographic opportunities at ford motor company

Ford Motor Company's population is 2,011.

Ford Motor Company's population is 164,000.

Did you check for power to the motor? If the switch doesn't work then the motor won't work. If there is power to the connector that hooks onto the motor then the part may be defective, if not then trace it back.

The code reader test connector, on your Ford E2 50, is located beneath the dashboard on the drivers side. The connector is on the left side of the steering column.

wer is the spout connector on 1992 ford e150 v8 5.0 liter

where do you find the diagnostics connector on a ford 1992 probe

Ford Motor Company was incorporated on June 16, 1903

Torques motor 4.0 ford ranger?