answersLogoWhite

Top Answer
User Avatar
Wiki User
Answered 2009-09-25 23:38:27

In the exhaust pipe before the catalytic converter, which is right behind the engine

001
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0
User Avatar

Your Answer

Related Questions


It is screwed into the exhaust manifold on the back of the engine.


It is a two wire sensor, very near where the upper radiator hose attaches to the engine.


There is one in each exhaust manifold.


There are two, one in each exhaust manifold.


RockAuto.com has auto parts and body parts for the 1994 Chrysler LeBaron at discounted and wholesaler closeout prices.


It has one oxygen sensor located on the rear exhaust manifold.



Lower radiator side of the engine.




It is screwed into the exhaust manifold.between the fire wall and the motor it will be on the muffler...



Chrysler doesn't use inertia switches. The fuel system is computer controlled with relays




Your question is confusing because it sounds like you want to remove the whole car.


The oxygen sensor is screwed into the exhaust before the catalytic converter.


Always use ATF3 or ATF4. Any other type of fluid in a Lebaron transmission will shorten the lifespan of the transmission.


where is the crank positioning sensor on a 1996 newyorker van


Chrysler does not use inertia or shut off switches. The fuel system is computer controlled with relays.



A cog and gear attached to the transmission which turns a worm driver attached to the tach


a convertible weighs 3010 lbs with no one in it, a coupe weighs 2863 with no one in it



should do.. Check the VIN Number, the 1993 and 1994 can be replaced without restriction, but if the production date is earlier, change the newer TCM module, too (even if it works with the older one, but the newer are better and your car will use less petrol



Copyright ยฉ 2021 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.