answersLogoWhite

0


Best Answer

It is located on the top of the valve cover, towards the back of the engine, under the upper intake plenum.

User Avatar

Wiki User

โˆ™ 2006-05-19 10:34:00
This answer is:
User Avatar
Study guides

Add your answer:

Earn +20 pts
Q: Where is the PCV located on a 1995 Ford F150 with a 4.9L and only 2wheel drive?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

Where is the PCV valve on a 1995 F150?

PCV is usually located on the valve cover sealed by a grommet. 1995 F150 2wheel drive with a 302 engine may require removal of the intake manifold. It is connected to an oil separator to keep excessive oil form entering the cylinder combustion chamber.


Where exactly is the fuel filter on a f150 4.2 2wheel drive?

Fuel Filter Location The fuel filter is located along the frame rail under the vehicle and is accessible only from underneath the vehicle.


Do you have stop the car to change to 4 wheel drive?

My f150 shifts from 2wheel to 4wheel on the fly, but to use 4low you need to be stopped with your transmission in neutral to engage the low range in my transfer case.


Where is the ford f150 wheel speed sensor?

its located at the rear drive axle


Where is the oil pressure sending unit located on a 1995 ford f150 wiith a 302 motor?

Where is the oil pressure sending unit on a 1995 F150 truck with a 302 motor at


Where is the fuel filter located on a 1995 F150 XL with duel gas tanks?

Where is the gas filter located on a 1995 F150XL pickup with duel gas tanks?


Where is the engine serial number located on a 1995 f-150?

Where is located the f150 engine serial number stamped in the block  


1995 ford f150 4.9 y Control Module - Ignition?

The ignition control module for a 1995 ford f150 is an important part of the drive train. If the module is failing then the engine will run erratically or not start at all.


Where is the fuel pump reset switch located on a 1995 ford f150?

passenger side kick panel.


Where is the tps located on an 01 f150?

where is the tps located on a 1994 f150


98 ford f150 is stuck in 4low anyway to just disengage the 4wd?

If you start the vehicle, put the trans in neutral, then put the 4wheel drive in 2wheel drive, then put trans back in gear it should disengage the 4wd. The 4wd drive is a electronic function. You may have to tap the brake pedal after you have selected 2 whl drive with the trans selector in neutral


Where is the solenoid located in a 1993 ford f150 6-cylinder 4.9 liter 2 wheel drive truck?

It's located on the side of the starter.

People also asked