Ford Expedition
Ford Expedition Eddie Bauer
Ford Expedition XLT

Where is the PCV valve in 1998 Ford Expedition?


Top Answer
User Avatar
Wiki User
2009-01-04 17:41:45
2009-01-04 17:41:45

PVC Valve Removal & Installation # Disconnect the oil separator hose from the PVC Valve. # Remove the PVC Valve from the grommet in the crankcase. Grasp the valve and gently remove it from the grommet in the passengers side valve cover. Remove the valve from the hose by carefully twisting it out. # Inspect the grommet for deterioration. To Install; # If necessary, replace the crankcase grommet. # Install the PVC Valve. # Install the hose.


Related Questions

the PCV is on top of the left valve cover if your engine is a 5.4 mostlikely it should be the same for the 4.6 hope this helps Jennifer

It's on the passenger side of the motor under the valve cover.

Do you mean PCV ? - ( Positive Crankcase Ventilation ) valve

on a 1998 Pontiac gan am ,they do not have a pcv valve.

Locate pcv valve on 1995 ford contour

Where is pcv valve on 1998 daewoo leganza

The pcv valve is on the passenger side valve cover

it's up under the manifold on the drivers side. Hunnybunny

The 1998 Cavalier does have a PCV valve. The valve is in the side of the valve cover, held in by a metal ring.

the pcv valve is located on top of the valve cover

The PCV valve is located on the passenger side valve cover. It cost about $3.00 to replace. Simply pull up on the vacuum line and the PCV will more than likely pull out of the gromlet. It may take a little effort, but pull the PCV valve from the line and install a the new one.

The PCV valve on 1992 ford mustang 5.0 is on the drivers side.

According to the 1998 Ford Escort Owner Guide : A Ford dealer will change the PCV valve at no cost ( except California and Canada ) at ( 60,000 miles/ 96,000 kilometers )

Disconnect the PCV valve tube from the PCV valve.Disconnect the PCV valve electrical connector if it has one.Turn the PCV valve counterclockwise to remove from the valve cover.To install, reverse the removal procedure.

On the 1998 Ford Explorer Sport with 4.6L V8 the positive crankcase ventilation (PCV) will be located on the driver's side of the vehicle. On top of the front-left engine valve cover will be a grommet and hose assembly. In between the grommet and hose, and attached to the valve cover is the PCV valve.

Did you ever find the location of the pcv valve?

where is the pcv valve on a 2007 ford sport trac

I have a 1998 Ford Escort ZX2 and the PCV valve was located to the right of the exhaust heat shield in front of the engine block. All I had to do was pull the rubber elbow out that was connected to the PCV valve and then pull the valve out. It was arguably the easiest maintenance work I've done on a car. I didn't have to take apart the heat shield or any other component.

# The PCV valve is located in the valve cover # Detach the hose from the valve then unscrew the valve from the valve cover

The PCV valve for a 1998 Monte Carlo should plug into the valve cover. Twist and pull it to remove and replace it.

PCV valve located on a 2003 ford f150 4.2?

The PCV valve on a 3.0 Ford Taurus is on top of the engine. Valve is at the front of the engine and is easily accessible.

That is the Positive Crankcase Ventilation ( PCV ) valve Depending on the model year and engine size there are different part numbers for the PCV valve

The most common place for a PCV valve is on the valve cover.

back right valve cover See "Related Questions" below for more

Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.