on the low pressure side
The PCV valve on a 1987 - 1990 Chevy Celebrity is in the top center of the valve cover nearest the firewall.
The heater core in a 1987 Chevy Celebrity is in the heater plenum to the right of the hump and below the glove compartment.
PCV valve is located inside a rubber tube that is in between the carb and the top of the valve cover. It's there, just hard to see since it's mostly covered by the rubber tube.
The location of the EGR valve on a 1987 to 1989 Chevy Celebrity depends on which engine the car has. If the car has the 2.8L V6 the EGR valve mounts to the plenum near the throttle body. If the car has the 2.5L 4 cylinder engine the EGR valve mounts in the center of the intake manifold near the valve cover.
The MAP sensor on a 1987 Chevy Celebrity is mounted to the firewall near the right fender.
The timing on y our 1987 Chevy Celebrity is controlled by the engine computer, there is no way provided to adjust it.
The idle speed on a 1987 Chevy Celebrity is controlled by the engine computer, there is no way provided to adjust it.
The fuel filter on a 1987 Chevy Celebrity is next to the fuel tank on the driver's side of the car/
To the drivers side.
The timing on a 1987 Chevy Celebrity is controlled by the engine control module, there is no provision for adjustment.
look under dash on drivers side, looks like a silver film cannister
It is the main computer box.
Here is a fact sheet on the Chevy celebrity http://auto.howstuffworks.com/Chevrolet-celebrity.htm/printable I found this really interesting
Camshaft sensors were not used on any of the Chevy Celebrity 2.5L, 2.8L or 3.1L engines
There is no MAF on a 1987 Chevy 2.5L engine.
most Chevy cps's are located in the timing cover(behind the balancer). I'm not certain on the Celebrity, but it would be a good place to check.AnswerOn my 1986 Celebrity 2.5, it is beneath the intake manifold on the back of the engine.
Please advise which engine and what year Celebrity you have. It's a 2.8L V6
The 1987 Chevy Celebrity has distributor less ignition. The timing is controlled by the engine control module and there is no provision for adjustment.
Not without modification.
Other than the 1987 and 1988 Eurosport VR versions I am unaware of any Chevy Celebrity with cup holders.
The horn is located in the engine compartment.