answersLogoWhite
Nissan Stanza
Ford E-150 Van
Ford Bronco
Ford F-150

Where is the PCV valve located on a 1988 Nissan Stanza wagon and is it in line on a hose or screwed into the intake manifold?


Top Answer
User Avatar
Wiki User
2007-04-18 23:46:42
2007-04-18 23:46:42

It's screwed into the intake manifold, toward the left as you're looking from the front of the car. It's not on top, but hard to see, behind the fuel rail assembly. You'll have to peek past #1 and #2 fuel injectors and their attendant hoses and you'll see a hose attached to a threaded fixture on the intake assembly. That's the PCV valve. I've been thinking of replacing mine even though it checks out fine, but not really looking forward to it, since it's in a reasonably inaccessable place. At least the valves are cheap and you only have to replace them every 30,000 miles or so. Best of luck...

Related Questions

User Avatar

The temperature sensor on a 1987 Nissan Stanza is located on the rear of the radiator. It is about one-third of the way down from the top.

User Avatar

The starter on a 1988 Nissan Stanza can be found on the inner side of the engine. It is between the gear box and the engine block.

User Avatar

Nissan Stanza was created in 1977.

User Avatar

it should be located in the exhaust , just past where it comes from the engine When you pull the engine up, look for where your manifold is. Go down to the bottom of it and it's right there, across from the radiator.


Copyright © 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.