answersLogoWhite

0


Best Answer

On my 1994 with a 3.8liter. i found it by popping the plastic shield off the area above the fuel injectors. saw a vertical stand pipe with a plastic cap. tiny letters "pcv" on it. removed the cap by giving it a 1/8 turn with a 3/8in drive. carefully, look to see which way it goes. you can just see the top of the pcv down in the pipe. needle nose to get it out. carefully note the o-rings on the old one. may need to use one of them on the new pcv.

User Avatar

Wiki User

โˆ™ 2005-04-12 18:37:21
This answer is:
User Avatar
Study guides

Add your answer:

Earn +20 pts
Q: Where is the PCV valve located on a 1989 Park Avenue?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

How do you replace PCV valve on 1995 Buick Park Avenue?

The PCV valve on a 1995 Buick Park Avenue is located on the top of the valve cover. Twist the valve and pull to remove and replace it.


Where is the PCV valve located on a 2002 park avenue?

The PCV valve on a 2002 Park Avenue is on the passenger side of the engine. It is close to the manifold under the map sensor.


What causes 1989 Park Avenue stalls?

My 1998 Park Avenue stalled. I cleaned the idle air control valve (IAC) and now it is fine.


Where is the pcv valve located on the 1997 buick park avenue?

on the left side of intake manifold under MAP sensor.


Where is the PCV valve located on a 1983 Buick Electra Park Avenue?

Hey Chris==It is in the right valve cover. There should be a hose from it to the intake or carb. GoodluckJoe


1989 Buick Electra Park Avenue blower motor location?

Blower motor is located on the firewall behind the engine.


Where is heater control valve on 1996 buick park ave?

were heater control valve for 1996 buick park avenue


What causes a Park Avenue to run rough or misfire and stall at redlights?

Check the Park Avenue EGR valve for a clog. A clogged valve can cause a rough idle and stall at a light.


1992 buick park avenue location of egr valve picture?

There is no EGR valve on the '92


Computer for 1989 buick park avenue?

For model year 1989 General Motors did not produce the Buick Park Avenue. The soonest production date to 1989 was the 1991 Park Avenue. The 1991 Park Avenue was offered in 3800 engine in supercharged or naturally aspirated. The part numbers for electronic control module (ECM) or "computer" will vary based on the exact engine for model year 1991s.


Where is the starter located on a 1989 Buick Park Avenue?

In front of the engine, below the exhaust manifold. You will find it nestled between the motor and transmission..


How do you program keyless entry remote for 1989 Buick Park Avenue?

The 1989 Buick Park Avenue does not come with a remote keyless entry. The keyless remote entry was not available till 1997.

People also asked