• Crankcases and PCV Valves
  • Geo Tracker
  • Grand Am SE

Where is the PCV valve located on a 1994 Geo Tracker?

User Avatar

Wiki User

βˆ™ 2008-03-30 21:34:00

Best Answer

If you get the chilton manuel for Suzuki Samurai/Sidekick/Tracker... #66500...1986-98, you can find the diagram on page 4-46. It is labeled as #10 on the diagram of the engine. It looks like it attached to the bottom edge of the fuel injection system. I hope this is of some use. p.s. this is for a 1.6 TFI engine.

2008-03-30 21:34:00
This answer is:
User Avatar

Add your answer:

Earn +5 pts
Q: Where is the PCV valve located on a 1994 Geo Tracker?
Write your answer...

Related Questions

Where is 1996 Geo Tracker PCV Valve?

most all pcv valves are located on the valve cover

Is the fuel PUMP in a 1994 Geo Tracker in the gas tank?

Is the fuel pump for a 1994 Geo Tracker in the gas tank

Where is the transmission drain plug located on a 94 Geo Tracker?

where is the trany drain plug on a 1994 ttracker

Where is the transmission fluid fill plug located on a 1994 geo tracker?

Near the back of the Engine in the middle.

Will a 1994 Geo tracker hard top fit on a 1993 tracker?

If it fit on a 1994, then it will fit on your 1993 with no problem.....

How can you tell if a 1994 Geo Tracker is an eight or 16 valve?

16 valve engine not put in a Tracker till 1996. 1994 Tracker is 8 valve (but a Sidekick may have the 16 valve in 1994) Actually there were 16 valve Trackers before 96. I have an early 95 which is 16v version. I believe 16v engines started somewhere between 91-94. I do know that the valve covers usually state 16 valve when it is. ,the spark plugs in a 16 valve are waaayy down in the top of the engine,you need about a eight inch extention to get at them

Will parts from 1987-1994 Geo Trackers work on a 1991 Geo Tracker?

yes,all tracker use the same parts

Where is the lever and how do you tilt the steering wheel on a 1994 Geo Tracker?

a lever is located on the left side of the column close to the dash

How do you take out bushings of a 1994 Geo Tracker that are stuck?

bigger hammer

Will the computer from a 1994 Geo Tracker work on a 1991 Geo Tracker?

Yes if it is the same trany. Auto will work in a manual but not the other way around. On_mitch

Where is the iat sensor on a 1993 geo tracker 16 valve 1.6?

Its on the Air box

What engine is in a 1995 Geo Tracker?

16 valve 1.6 liter 4 cylinder.

How tight should the head bolts be on a 1994 Geo Tracker Also how tight should the valve cover bolts be?

46-50 ft.lbs. 46-50 ft.lbs.

Where is the fuel filter located on a 1991 Geo Tracker?


How do you set the timing on 1994 Geo Tracker?

It isn't adjustable. It is controled by the computer

Where is the gas filter in 1994 Geo Tracker?

It is in a brace in front of the gas tank.

What should the torque be on the main bearings of a 1994 Geo Tracker?

you can find it at

Lug paTtern for a 1994 Geo Tracker?

the bolt pattern is 5on 5x5

How many gallons of gas can a 1994 Geo Tracker hold?

about 8.5 gallons

What is the oil capacity for a 1994 goe tracker?

Hi, The oil capacity for the 1994 Geo Tracker with the 1.6 engine is 4.5 quarts with the filter. Steve H.

Where is your IAT sensor on your 1990 Geo Tracker?

The 1990 Geo Tracker IAT sensor is located on the top of the transmission. The IAT sensor will be near the back of the transmission.

Can you put a 1995 Geo Tracker engine into a 1997 Geo Tracker?

if they are both 16 -valve engines ,yes if one is 8-valve & the other is 16-valve, then short block only ANSWER: The '95 and '97 Trackers have different sensors and ECU's. The only way you could put a '95 engine in an '97 TRacker would be if you also had the ECU from the '95

Engine idlesup and down at cold start on 92 geo tracker what could it be?

its the RAR valve.

Where is the hood release located on a 1996 Geo Tracker?

in the glove box

Where is the horn located on the 1996 Geo Tracker?

between the grill and the rad