I own a 1990 F-150 with a 302. When i had to replace mine, it was hidden underneath intake manifold, so check around there, i know we have have trucks that are 4 years apart with different enginges but hey, maybe you'll get lucky. DIRECTLY BEHIND THE INTAKE MANIFOLD. LOOK AT THE PASSENGER SIDE VALVE COVER ALL THE WAY TOWARDS THE FIREWALL, A HOSE WILL COME OUT OF IT AND LEAD DIRECTLY TO THE PCV VALVE, FROM THERE IT GOES BACK INT THE INTAKE MANIFOLD. CLIMB ON THE FRONT BUMPER AND LEAN IN!
I have a 1994 Suburban with the 7.4 litre 454 cubic inch engine and the PCV valve is located in the right (passenger) side valve cover.
The EGR valve on a 1994 Chevy 1500 is located on the top of the engine. If the valve becomes stopped, the engine could idle rough or stall.
It is probably located on top of the valve cover on the right hand side of the engine.
The EGR valve on a 1994 Oldsmobile Bravada is located on top of the engine on the left side. It pulls in a small amount of exhaust gases to be re-circulated through the engine.
on top of the valve cover
The egr valve is located on the top rear of the engine. It bolts on and is easily removed.
its located on the drivers side back side of head pan
Under hood, center, upper engine area, mounted in rear of valve cover
The egr valve is located on the back center of the engine. It is right under the intake manifold.
It is located at the passenger side rear of the valve cover under the intake manifold.
The PCV valve is located in the rear valve cover next to the firewall. It can be reached and changed without rotating the engine forward although it is a bit of a struggle.
For the engine oil , it is on the passenger side valve cover
In back of the engine on the drivers side.
The PVC valve on a 1994 impala is located on the valve cover. It is close to the dip stick end.
There is NOT an EGR valve on this engine.
No, you do not have to remove the engine to do a valve job.
It is located in the right valve cover.
Idle Speed/Throttle Actuator - ElectronicFront RH Side Of Engine
The PCV valve on a 1994 Regal Custom should be located on top of the valve cover. It is a plug in type and is easily changed.
The PVC valve is located in the breather separator under the intake manifold.
on a 93 GXE SOHC engine, it's located on top of engine, facing rear firewall and has a rubber hose entering from rear. buy part and you'll be able to match it to where it goes into the engine.
Where is the starter located on a 1994 altima engine
The PCV valve on the 4.9L I6 engine is nearly impossible to see. It is located at the top of the valve cover near the rear of the engine forward a few inches from the center of the firewall. It is easier to see and reach it if you use a step stool.
Under top engine cover that says 32 valve Northstar between both cylinder heads. Good luck
located on the cam shafts there are two marks one on each that have to be aligned!