Honda Civic SI

Where is the PCV valve located on a 1998 Honda Civic SI?

113114115

Top Answer
User Avatar
Wiki User
2005-08-26 02:39:04
2005-08-26 02:39:04

They didn't make and Si in 1998. The PCV valve is on 1998 Civic SI's are located on the bottom of the intake manifold. It is acessed from the bottom of the car, you have to remove the oil filter to reach it.

1
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions

User Avatar

My 1998 Civic EX engine (CA emissions) vents the upper valve cover into the air intake for combustion. I could not locate a traditional Positive Crankcase Ventilation (PVC) valve on my vehicle.

User Avatar

The wiper motor for a 1998 Honda Civic is located on the firewall, underneath the vent cover, below the wipers.

User Avatar

How do you change the starter on a 1998 Honda Civic ex?

User Avatar

The dipstick is located behind the steering wheel.

User Avatar

1998 Honda Civic CX HB MT 2295 1998 Honda Civic CX HB AT 2357

User Avatar

in the catalyc converter... exhaust manifold

User Avatar

1998 Honda civic DX should have a 107 HP stock

User Avatar

The thermostat on a1998 Honda Civic is found on the right side of the engine. It is located in the thermostat housing which can be found by following the lower radiator hose.

User Avatar

The headlights on a 1998 Honda Civic use adjustment screws which are located on the side of each headlight in the engine bay. Tightening it will raise the light and loosening it will lower it.

User Avatar

The pcv valve is located under the intake manifold. By folowing the hose out of the top side of the said maniforld it runs directly into the valve. By removing the oil filter one can remove the old valve by prying and twisting it out.

User Avatar

Should be located just above the oil filter.

User Avatar

The PVC valve is located at the tip of the small hose plugged into the top of your valve cover. It is located between the manifold and the top valve cover.

User Avatar

The expansion valve, on your 1998 Honda Accord, is located just before the thermostat housing. You can follow the water hose from the radiator to the expansion valve.

User Avatar

The valves on a 1998 Honda Civic EX can be adjusted using a feeler gauge. First remove the valve cover to access the valves. Using a factory service manual look up the proper valve adjustment gauge. Using a special valve socket to tighten and loosen them to the appropriate feeler gauge settings.

User Avatar

It is mounted on top and inside the fuel tank.

User Avatar

the VSS is right on top of the Transmission with a plug on top of the VSS

User Avatar

Take it to a Honda Civic garage / mechanic.

User Avatar

The only item that I can think of which could be classed as an air intake valve would be located in the cylinder head above the piston. It sits next to the exhaust valve. It opens in order for the fue / air charge to enter the cylinder.

User Avatar

The ignition coil on a 1998 Honda Civic LX is located under the distributor cap. The distributor is on the passenger side of the motor and has wires running from it to each spark plug. it is usually plastic.

User Avatar

If the 1998 is a Civic then yes it will fit.

User Avatar

its on the firewall...its all black with two bolts with lines on it

User Avatar

Its @ the bottom of radiator kinda n da middle of it.

User Avatar

To disable an anti-theft system on a 1998 Honda Civic locate the brain. The controls all function of the alarm system. Once located unplug it from the wire harness.

User Avatar

It depends on the model. D16Y8 Honda Civic EX 1996-2000 D15Z Honda Civic HF 1996-2000 D15Y7 Honda Civic DX/LX/CX 1996-2000

User Avatar

It is located directly above the transmission. There is a detachable wire harness.


Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.