Pontiac
Nissan Maxima
Ford F-150
Grand Am SE

Where is the PCV valve located on a 1998 Pontiac 38 engine 3800 series?

131415

Top Answer
User Avatar
Wiki User
2008-07-16 02:10:23
2008-07-16 02:10:23

It should be below the plastic cover....under a 5v sensor to the left side of the intake manifold...it's there, below the 5V sensor...go here to check it out: http://macgp.clubgp.com/howto/pcv/pcv.html ...it is a very similar setup and you should be ok. Good luck...be careful not to crack the plastic...note position etc...

1
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions

User Avatar

The 2001 Pontiac Grand Am 2.4 liter engine PCV valve is located on the firewall. The valve will be on the drivers side firewall in the engine compartment.

User Avatar

You can find the PCV valve beneath the MAP sensor located in the plenum at the right front of the engine.

User Avatar

on a 1998 Pontiac gan am ,they do not have a pcv valve.

User Avatar

It's the pcv valve (pressure control valve), and it's located on top of the engine block to the right hand side, can't miss it.

User Avatar

Pontiac PVC Valve is located on the Driver's side rear valve cover.

User Avatar

The PCV valve is located directly ontop of the engine block and is connected by a rubber hose on one end connected into the engine with the other end you will find it on the lower right (topside) of the engine : D

User Avatar

It is located on the drivers side of the engine right next to the crank case..........and I think that you mean EGR valve.

User Avatar

As I recall, that engine does not have an EGR valve.

User Avatar

where is valve cover located on a 2001 Pontiac Grand-Am 4 cyl

User Avatar

there is hose running from the top of the engine to the air intake. your pcv valve is located on the engine side of that hose. Mostly correct except there is no PCV valve; there's just a straight pipe going from the valve cover to the air plenum intake hose. Hope this helps. RJK75

User Avatar

The coolant bleeder valve should be on the front passenger side of the engine. It will be on one of the metal hoses. The bleeder valve on the 3400 V6 engine is located on a black stem where the water pump connects to the engine block.

User Avatar

the PVC valve should be located on the valve cover by the intake manifold on top of your engine block

User Avatar

The 2003 Pontiac Montana EGR valve is located on the firewall. The valve will be on the driver side of the firewall.

User Avatar

The PCV valve on a 2002 Pontiac Bonneville is located on the back of the in take manifold, however to get to the PCV valve you will need to remove the valve cover.

User Avatar

The EGR valve is located on the side of the intake on the 2000 Pontiac Grand Am. It is close to the intake manifold.

User Avatar

The EGR Valve on a 1999 Pontiac Firebird is located just to the left of the engine oil dipstick. There's nothing in the way so it's pretty easy to get to and replace. Hope this helps! -Erin

User Avatar

it is on the rear valve cover.very hard to get to..The pcv valve is not visible on a 3800 series II engine, which I presume you have in your Grand Prix, because it is located under the MAP sensor. You will find that at the front of the engine, where the serpentine belt is located. Unplug the connector to the MAP sensor and then you will have to unclip the sensor itself. You will then see pcv valve underneath.3For a 3800 normally asperated check out the following website for pics and instructions. http://www.scacgp.com/mods/gt_pcv.htm."G"

User Avatar

Sorry I am not sure how to describe this, but this is a diagram of a Bonneville and its in the exact same location,

User Avatar

The PCV valve is located under the MAP sensor on a 1990 Pontiac Grand Prix. The MAP sensor is in the upper plenum.

User Avatar

Probably in the 1997 Pontiac trans-am heater core valve holder. If not, you probably lost it. Both the valve, and your mind.

User Avatar

On the 2.4 liter engine it is located on the front of the engine just left of center. It has a set of wires plugged into it and it has two star head nuts holding it to the engine block.

User Avatar

To answer this, first i need to know what size engine you have. Is it a 2.3L 4 cyl or a 3.3L 6 cyl.

User Avatar

The EGR valve is located beside the throttle body on the right side. This is a digital valve so if your looking for vacuum lines there aren't any. It will have a 5 wire plug attacked.

User Avatar

It is located on the valve cover..back of the engine.


Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.