The PCV valve on the KA24E 4-cylinder is located in front of the oil filter and above the alternator. It points to the rear of the engine. You will need only two tools; a stubby 19mm open end wrench and a pair of pliers to remove the hose clamp. I did it without removing anything else. Just reach around to the right of the oil filter. It took about 15 minutes. Here is a pic:
On a 1987 Nissan Hardbody Pickup, the PCV valve is located between the alternator and the oil filter. The valve can be seen when the oil filter has been removed.
On The passenger side of the motor between the Firewall and the Throttle body
where is the pcv valve located 1994 nissan pick up 4wd 2.4l
1995 nissan pickup has a expansion valve rather than a orfice tube and is located on the evap.
Under the truck on the passager sideof the truck. You will see a rubber hose that's connected to it.
below the right side of carb.
if I knew the answert I wouldnt be here!!
The valves in a 2.4 L Engine Are not Adjustable
In the ac box
insid ac box at floor board.
in back of the alt you can fill it but can not see it take alt out of way to get to it
first its an egr valve and its between the exhaust manifold and the exhaust pipe itself usually on the passenger side
The expansion valve is located in front of the evaporator core. You must remove the housing to access it.
It is bolted to the bottom of the throttle body.
the air intake valve is located on the side if your air cleaner/air box.
PCV valve is located under the hood, center, upper engine area, mounted in intake manifold.
It should be down below where the slave cylinder connects to the tranny
on my 97 hardbody ka24e the egr is under the breather behind the throttle body to the left a bit. It is round metal and has a diphragm under it you can press up on to close the valve which is one of the tests to see if it is failing.
None that I'm aware of, but you'll need to check with a Nissan dealership. I know I had a recall on my 96 XE, but that was for a valve in the fuel system.
On a lot of these vehicles, the PVC valve is located on top of the valve cover, or a hose leading from the valve cover to the intake. You have to remove the right front wheel. It will be in the block. It is in an awkward place and Nissan charges about a 100.00 to install it. You can do it your self though.
the cap is open
On the 1997 Nissan pickup its just above the oil filter, lower right of engine, access through right front wheelwell after removing wheel, it's a screw in affair.
Yes, most definitely.
It is very important to change PCV valve. If valve is old it will plug or seize. This will cause oil pressure to rise and may cause leaks. Most likely the valve cover gaskets will leak if PCV valve is plugged.