EGR Systems
Crankcases and PCV Valves
Toyota SR5
Ford Expedition Eddie Bauer

Where is the PCV valve on a 1998 expedition?

555657

Top Answer
User Avatar
Wiki User
2006-03-24 03:40:37
2006-03-24 03:40:37

on the left falve cover close to the firewall (small black plastic cilinder with black rubber hose on top) just pull out to remove.

1
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions

User Avatar

on a 1998 Pontiac gan am ,they do not have a pcv valve.

User Avatar

Where is pcv valve on 1998 daewoo leganza

User Avatar

The 1998 Cavalier does have a PCV valve. The valve is in the side of the valve cover, held in by a metal ring.

User Avatar

the PCV is on top of the left valve cover if your engine is a 5.4 mostlikely it should be the same for the 4.6 hope this helps Jennifer

User Avatar

# The PCV valve is located in the valve cover # Detach the hose from the valve then unscrew the valve from the valve cover

User Avatar

The PCV valve for a 1998 Monte Carlo should plug into the valve cover. Twist and pull it to remove and replace it.

User Avatar

The 1998 and newer S10 with the 2.2L engine does not have a serviceable pcv valve.

User Avatar

It's on the passenger side of the motor under the valve cover.

User Avatar

It is in the driver side valve cover, you must change the valve cover to replace the PVC valve.

User Avatar

Hi. PCV filters are no longer used on cars after 1998. Having a Saturn ion, I know there is no PCV valve. Hope this helps you.

User Avatar

I would say that my 1998 S-10 does not have a PCV valve, at all, anywhere.

User Avatar

Yes. The PCV valve is attached to the intake by a hose and is located in the valve cover and held by a plastic retainer. Use a pair of pliers to loosen the PCV valve retainer. Unthread the retainer from the valve cover to expose the PCV valve. Pull the PCV valve from the valve cover grommet and remove the valve from the hose.

User Avatar

Do you mean PCV ? - ( Positive Crankcase Ventilation ) valve

User Avatar

You can find the PCV valve beneath the MAP sensor located in the plenum at the right front of the engine.

User Avatar

where is the pvc valve on a 1998 suaru forester?

User Avatar

The PCV valve is located on the passenger side valve cover. It cost about $3.00 to replace. Simply pull up on the vacuum line and the PCV will more than likely pull out of the gromlet. It may take a little effort, but pull the PCV valve from the line and install a the new one.

User Avatar

On my 1997 Protege a hose runs from the valve cover to the air intake assembly. Where the hose connects to the valve cover is the PCV valve.

User Avatar

THERE ISNT ONE THERE IS A PCV VENT LOCATED AT THE REAR OF THE ENGINE

User Avatar

The exact location of the PCV valve on a 3.8L engine depends on the year. On models 1995 through 1998 and 1999 and 2003, it is on the front valve cover. However, on 1996 through 1998 models it is on the rear valve cover.

User Avatar

The PCV is usually located in the valve cover(s). They just slip into a rubber grommet; no tools required.

User Avatar

1998 and newer 2.2L engine does not have a serviceable pcv valve.

User Avatar

Pull upward on the hose that the PCV valve is in. The PCV valve will pull out of the hose. The PCV valve is located in the valve cover.

User Avatar

They didn't make and Si in 1998. The PCV valve is on 1998 Civic SI's are located on the bottom of the intake manifold. It is acessed from the bottom of the car, you have to remove the oil filter to reach it.

User Avatar

The PVC valve on a 1998 firebird is on the passenger side. It is on the valve cover about halfway between front and back.


Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.