Your pcv valve is buried under the carburators, you can see it sticking out of a smaller black box, it also has a small hose coming out of it. Any more questions on the subject email me. I have an '87 prelude dual carb, I am looking for a quality set of carbs for this car, one of the carbs is running extremely rich.
On the crossbars of the steering wheel.
The 1986 Honda Prelude does not have a clutch cable. The 1986 Prelude has a hydraulic clutch instead of the clutch cable.
The 1986 Honda prelude 2.0 Si has a A20a3.
my Honda prelude 1986 si wants to cut off after its warmed up . any sugestions on what ot could be
is inside the alternater
inside the trunk?
86 prelude pcv locationThe 1986 1987 Honda prelude pcv valve is in the middle under the intake. It has a hose running through an opening on the intake. It is only accessible by removing the intake. The intake is very hard to remove in the carbecause the bottom bolts are so hard to get to.
Make sure your computer has no viruses
the dashes are pretty similar but some of the plugs are different.
Programed Fuel Injection
They do if it is an automatic transmission. The Prelude (except Si) has the same manual transmission as well. The Prelude Si has a slightly different manual transmission, but it will still fit into a 1986-1989 Accord.
Intake valve .003, exhaust valve .005.
its like my 91 Prelude 5 speed transmission is stuck in 2 gears.It is wielded.
the best swap would be a JDM vtec 2.2 liter. you can get a 2.2 liter vtec out of something like a 2001 Honda prelude but you would have to do the wiring harness
You need to replace the entire headlight. Only remove the screws that hold the trim in place. Don't back out the adjustment screws.
Most vehicle manufacturers now put the regulator inside the alternator.
This is the most gramatically incorrect question ever, but I belive the Corlolla is faster on a racetrack.
HorsepowerHeres the Honda engines hope you can find yours B20A (16-Valve, 4 Cylinder, DOHC, PGM-FI)Found in: Serial numbers 1000001~, 1500001~ and 1550001~ (Gold Valve Cover) 1985-1986 Honda Prelude Non-U.S. 1985-1986 Honda Accord Non-U.S. 1985-1986 Honda Vigor Non-U.S. Serial numbers 1600001~ and 1640001~ (Black Valve Cover) 1987-1989 Honda Accord Non-U.S. 1987-1989 Honda Vigor Non-U.S. Displacement: 1958 cc Compression: 9.4:1 Power: 160 hp @ 6300 rpm & 140 ft�lbf @ 5000 rpm Transmission: B2K5, F2K5B20A (16-Valve, 4 Cylinder, DOHC, PGM-FI)Found in: 1987-1990 Honda Prelude Japan Domestic Market This carries the same engine code as the original B20a above, but is actually a different engine. The serial number for these B20A will be: 5000001~B20A2 (16-Valve, DOHC, PGM-FI)Found in: 1986-1989 Honda Accord Non-U.S.B20A3 (12-valve, SOHC, dual side-draft carburetors)Found in: 1988-1991 Honda Prelude 2.0 S HorsePower: 104 @ 5800 (MT) 105 @ 5800 (AT) Torque: 111 @ 4000B20A4 (12-Valve, SOHC, dual side-draft carburetors)Found in: 1988-1991 Honda Prelude Non-U.S.B20A5 (16-valve, DOHC, PGM-FI)Found in: 1988-1991 Honda Prelude 2.0Si Power: 135 hp Engine cc: 1958.14 Cylinder cc: 489.535 Deck cc: 13.885 Head cc: 47.3 Compression Ratio: 9.0:1 engine using a pk-2 Honda ECU based on oki83c154 processor (Intel 8051 based with external ROM)B20A6 (16-Valve, DOHC, PGM-FI)Found in: 1988-1991 Honda Prelude Non-U.S. New Zealand, and Australian Domestic Market 140hp@6000rpm 170nm@5500rpm KY model is one of themB20A7 (16-Valve, DOHC, PGM-FI)Found in: 1988-1991 Honda Prelude Non-U.S. UK, France, Holland, Norway, South Africa Power 150 hp@6000 rpm Torque 180Nm@5500 rpm Compresion ratio 10.5:1B20A8 (16-Valve, DOHC, PGM-FI)Found in: 1988-1991 Honda Prelude Non-U.S. Russian, Swedish Domestic MarketB20A9 (16-Valve, DOHC, PGM-FI)Found in: 1990-1991 Honda Prelude Non-U.S. Finland, German, Norway, Netherlands, Russia, Argentina Power 140 hp@6000 rpm Torque 175Nm@4500 rpm Compresion ratio 10.5:1B21A (16-valve, DOHC, PGM-FI)Found in: 1990-1991 Honda Prelude Si States Very rare, it was only produced for the "Si States" models in Japan. There is an old myth that this engine produces 175+ HP, this is completely false.B21a:HP: 145 @ 5800 RPMTQ: 137 @ 5000B21A1 (16-valve, DOHC, PGM-FI)Found in: 1990-1991 Honda Prelude Si Power: 140 hp @5800 rpm Torque: 135 lb.ft @5000 rpm Engine cc: 2056.03 Cylinder cc: 514.0075 Deck cc: 10.191 Head cc: 51.0 Compression Ratio: 9.4:1 Torque (lb.ft. @ rpm): 135@5000
The 1986 Jeep Comanche EGR valve is located on the outside of the air cleaner housing. The valve can be found on the back of the housing.
Yes Actually they can have either. The "S" models are carbs. The "Si" models are fuel injected.
add an air intake and full exhaust system if you havent yet done that
on top of oil filter plate it has one wire
Valve clearance (cold) Intake 0.005 to 0.007 in Exhaust 0.010 to 0.012 in