Late Model 1979-New Ford Mustangs
1982-1994 Chevy Cavaliers
1995-2005 Chevy Cavaliers

Where is the PVC valve located on a 1993 22ltr 4-cylinder Cavalier?

345

Top Answer
User Avatar
Wiki User
2008-05-02 04:41:09
2008-05-02 04:41:09

passinger side back corner of valve cover

1
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions

User Avatar

The PCV valve on a 2002 Chevy Cavalier is located on the back of the valve cover. It is a plug in type.

User Avatar

The EGR valve is directly under the hood on the 89 Cavalier.

User Avatar

The knock sensor for the 1993 Chevy Cavalier is located in the back of the motor. It can also be located in the engine valve.

User Avatar

where is the shift solenoid valve (2-3) located on 2000 chev cavalier

User Avatar

The pcv valve should be located on the top of the valve cover. It is located closer to the rear of the motor.

User Avatar

The PCV valve is located on the top of the valve cover. There will be a large vacuum line connected to it.

User Avatar

It is located in the valve cover. There will be a large vacuum hose that goes to it. Always purchase a quality valve as it is very important for crankcase ventilation.

User Avatar

its on the right side of the valve cover, near the power steering pump.

User Avatar

The PCV valve is located on the right side of the valve cover. After removing the hose, there is a retainer clip then the valve can be removed with pliers.

User Avatar

The PCV is usually located in the valve cover(s). They just slip into a rubber grommet; no tools required.

User Avatar

under what appears to be the valve cover on top of the engine

User Avatar

where do I find the egr valve on a 1999 Chevy Cavalier?

User Avatar

The PCV valve is attached to the intake by a hose and is located in the valve cover held by a plastic retainer on the passenger side of the engine near the power steering reservoir.

User Avatar

The 1998 Cavalier does have a PCV valve. The valve is in the side of the valve cover, held in by a metal ring.

User Avatar

Not exactly sure about a 99 but almost all cars it is a valve that goes right into to your valve cover around where you fill your oil.

User Avatar

The purge valve solenoid on your 2001 Chevy Cavalier is located on the side of the engine. It is mounted on the block right below the intake manifold and can be distinguished because of the bracket attached to it.

User Avatar

There isn't one on the 2200 motor. If there was, it'd be under the breather tube going from the valve cover into the intake resonator.

User Avatar

Try looking on the head, on the passenger side of the throttle body

User Avatar

No pcv valve that can be serviced, the 1998 and later 2.2L OHV engines are equipped with an oil/air separator that is located inside the valve rocker arm cover that requires no maintenance. I have a 1998 Cavalier RS Coupe and I love it, also love my 2003 Mustang.

User Avatar

To replace the valve lifters on a Cavalier, remove the intake manifold, valve covers and rocker arms. Remove the heads of the lifters using needle-nose pliers.

User Avatar

The 2004 Chevrolet Cavalier idle air control valve can be found on the firewall in the engine compartment. The valve will be on the passenger side of the firewall.

User Avatar

As with all valve gaskets it is located between the valve cover and the head. To get to it you undo all bolts holding the valve cover on and then pull valve cover off. you will find it on the valve cover/ head contact point.


Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.