I found in a chiltons' manual that the PCV valve for my 96 V6 was located under the MAP sensor. I had to remove the MAP sensor by twisting it CCW. Take care not to loose the O-ring in the sensor housing or the O-ring that fits around the PCV. The map sensor is located under the plastic engine cover.(If you have one)The cover must be removed. If you're at the car's front bumper looking at the engine. The map sensor is sitting to the Left side in front of the altenator. If you look closely in small print you will see "PCV" written on the lip of the sensor housing.AnswerIf it is like the 1994 Pontiac Bonneville the it is in the front of the motor between the altanator and Power Steering pump. There is a piece of plastic that had a small square about the size of a quarter inch ratchet. turn this piece and under it is a spring and a round o ring. remove ther two pieces and with needle nose pliers reach in and remove the PCV valve. There is also an o ring on the bottom of the valve.
'How do you change a fog light in a 1996 Pontiac Bonneville? ... How do you
Should be at the passenger side firewall
How to remove left inner door panel of a Pontiac Bonneville 1996
It is located top left of the motor if you are looking at it from the front bumper
diagram for serpentine belt on 1996 Pontiac Bonneville se
Yes. It should fit it well.
with a scan tool
If the Bonneville is like my GTP then the fuel filter is in front of the fuel tank
driver side of the front valve cover if its the V6 if its the 4 cyl. its on the top of the valve cover somewhere
probably out of gas
There is none to find.
A 1996 Pontiac Bonneville requires 5.7 quarts of oil in the crankcase. The oil filter should also be changed with the oil.
Standard V-6 will be 0.06
You need to take of the door panels!
Check your owners manual to find the location of your fuses. There should be a diagram showing where each fuse is located.
Where is the the heater control valve??
The sensor is located on the right side of the the crankshaft attached by 2 bolts thru the timing cover it will be hard to see due to the pulley.
I own a 1996 bonneville. The tensioner bolt is a reverse threaded bolt, (tighten to loosen). Hope this helps. DCC
I need to know where the fuel pump is located and how to get to it on a 1996 Pontiac sunfire gt
where is the evap purge valve located in a 1996 jimmy
On my '95 Bonneville the trunk release button is on the driver's door below the door handle. Hope this helps.
Go here for your answer: http://www.cardomain.com/memberpage/338233/4
I have a 1996 Bonneville and it has a Phillips head screw on each side of the armrest. If yours is like that then you should be able to just unscrew them and pop it out.