To change PVC valve on a 1993 Nissan 300zx, first remove the oil dip stick and remove the tension clip from the PVC valve hose. Then remove the hose and the old PVC valve. Replace with a new PVC valve.
the PVC vlave is located in a hole on the top of the valve cover next to the oil fill cap.
It does not. I have a '93 Summit Wagon, that does not have it. I'm pretty sure it was in '94 they added a driver side airbag, and a passenger one in '95.
It's next to the back of the front-right turn signal lamp. Look up from below.
It's on the front valve cover of the engine, it just pushes into a rubber grommet and there is a hose coming off of it.
im not sure on a 1990 but on my 93 civic ex 1.6 vtec the PVC valve is on the intake right under the fuel rail
fuel pump will be in the fuel tank, there will be an access panel hidden under the carpet so that you do not need to remove the tank from the vehicle. hope this helps
do you mean the PCV valve? the PCV valve is located in the intake manifold
egr valve may be clogged or bent. where do i find the egr valve on my 93 Saturn sc2?
Has anyone looked ay the timing belt? Or done a compression test ? that's a pretty broad question.
more the likely the distributor but check easy things 1st cap rotor ect... i know i own one too!ive replaced mine 2 times in 4 years!
on a 93 GXE SOHC engine, it's located on top of engine, facing rear firewall and has a rubber hose entering from rear. buy part and you'll be able to match it to where it goes into the engine.
It is in the valve cover.
crankshaft position sensor wiring eagle vision
Its under your drivers seat
The low pressure valve on a 93 Chevy Corsica is under the hood. It is on the larger hose coming off the AC air compressor.
the valve cover torque specs are 85in lbs
you have to remove the trans and flywheel.
Not without modification
(NO) that sez you can add a valve on the pump side.
No Ford Escorts have a fuel overflow valve.
On the fuel rail of the 93 explorer there is a pressure valve. With the battery disconnected, place a rag around the valve to catch any fuel. depress the valve until the fuel stops coming out.
There isn't one for that model.
under throttle body at intake
A 1993 Jeep does not have a transmission modulator valve.